Panasonic KX-TG7100 Operating Instructions Manual

Also see for KX-TG7100: Service manual

Multi-unit Operation28 Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333Operating additional unitsAdditional handsetsUp to 6 handsets can be registered to thebase unit. Additional handsets will give youthe freedom to, for example, have anintercom call with another handset while athird handset is on an outside call. See page5 for information on ordering additionalhandsets.Important:L The additional handset modelrecommended for use with this unit isnoted on page 5. If other model handset isused, certain operations (handsetsettings, base unit settings, etc.) may notbe available.Registering a handset tothe base unitThe included handset and base unit arepreregistered. If for some reason thehandset is not registered to the base unit (forexample, w flashes even when the handsetis near the base unit), register the handsetmanually (page 28).To register an additional handset to thebase unit (easy registration)After purchasing an additional handset,register it to the base unit. Ensure that theadditional handset is switched on. If it is noton, press and hold {ih} for few secondsto turn the handset on.1 Lift the additional handset and press{ih} to put the handset in standbymode.2 Press and hold {x} on the base unit forabout 3 seconds, until the registrationtone sounds.3 Place the additional handset on thebase unit. The registration tonecontinues to sound. With the handsetstill on the base unit, wait until aconfirmation tone sounds and w stopsflashing.Note:L If an error tone sounds, or if w is stillflashing, register the handset manually(manual registration; page 28).L If all registered handsets start ringing instep 2, press {x} to stop. Start again fromstep 1.L Charge the batteries of your additionalhandset for about 7 hours before initialuse.L This registration method cannot be usedfor handsets that have already beenregistered to the base unit. Register thehandset manually (manual registration;page 28).To register a handset to the base unit(manual registration)You can register a handset to the base unitmanually using the following method.1 {j/OK} i “Handset Setup” i{>}2 “Registration” i {>}3 “Register H.set” i {>}4 Press and hold {x} on the base unit forabout 3 seconds, until the registrationtone sounds.L If all registered handsets start ringing,press {x} to stop, then repeat thisstep.L After pressing {x}, the rest of thisprocedure must be completed within 1minute.5 Wait until “Enter Base PIN” isdisplayed, then enter the base unit PIN(default: “0000”), then press {j/OK}.L If you forget your PIN, see page 35.TG7100-7120E(e).book Page 28 Tuesday, July 4, 2006 3:29 PM