Multi-unit Operation38 Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 83333 “Register H.set” i #4 Select a base unit number. i #L This number is used by the handsetas a reference only.5 Press and hold {x} on the base unit forabout 3 seconds, until the registrationtone sounds.L If all registered handsets start ringing,press {x} to stop, then repeat thisstep.L After pressing {x}, the rest of thisprocedure must be completed within 1minute.6 Wait until “Enter Base PIN” isdisplayed, then enter the base unit PIN(default: “0000”), then press #.L If you forget your PIN, see page 47.L When the handset has beenregistered successfully, w will stopflashing. If keytones are turned on(page 20), a confirmation tone will beheard.Selecting a base unitWhen “Auto” is selected, the handset willautomatically use any available base unit itis registered to. When a specific base unit isselected, the handset will make and receivecalls using that base unit only. If the handsetis out of range of that base unit, no calls canbe made.1 " (middle soft key) i N i #2 “Select Base” i #3 Select the desired base unit number, or“Auto”. i #L The handset starts searching for thebase unit.Cancelling a handsetA maximum of 6 handsets can be registeredto a base unit. A handset can cancel its ownregistration (or the registration of anotherhandset) that is stored in the base unit. Thiswill allow the base unit to “forget” thehandset.1 " (middle soft key) i L i #2 Enter “335”.3 “Cancel Handset” i #L The numbers of all handsetsregistered to the base unit aredisplayed.4 Select the handset(s) you want tocancel, by pressing the desired handsetnumber. i #5 “Yes” i # i {ih}Cancelling a base unitA handset can be registered to a maximumof 4 base units. A handset can cancel a baseunit that it is registered to. This allows thehandset to “forget” the base unit.1 " (middle soft key) i N i #2 “Registration” i #3 Enter “335”.4 “Cancel Base” i #5 Select the base unit(s) you want tocancel, by pressing the desired base unitnumber. i #6 “Yes” i # i {ih}Note:L To register the handset to another baseunit or to the same base unit again, seemanual registration (page 37).TG8100-8120E(e).book Page 38 Friday, March 3, 2006 10:34 AM