Panasonic KX-TGD390C Operating Instructions Manual

Remote commandsKey Operation1 Repeat message (during playback)2 Skip message (during playback)4 Play new messages5 Play all messages9 Stop playback0 Turn answering system off*4 Erase currently playing message*5 Erase all messages*# End remote operation(or hang up)Turning on the answering systemremotely1 Dial your phone number from atouch-tone phone.2 Let the phone ring 15 times.R A long beep is heard.3 Enter your remote access code within 10seconds after the long beep.R The greeting message is played back.R You can either hang up, or enter yourremote access code again and beginremote operation (page 26).Answering system settingsCall screeningWhile a caller is leaving a message, you canlisten to the call through the handset’s speaker.1 MMENUN#3102 MbN: Select the desired setting. aMSAVEN a MOFFNNumber of rings before the unitanswers a callYou can change the number of times thephone rings “Ring count” before the unitanswers calls. You can select 2 to 7 rings, or“Toll saver”.The default setting is “4 rings”.“Toll saver”: The unit’s answering systemanswers at the end of the 2nd ring when newmessages have been recorded, or at the endof the 5th ring when there are no newmessages.1 MMENUN#2112 MbN: Select the desired setting. aMSAVEN a MOFFNCaller’s recording timeYou can change the maximum messagerecording time allowed for each caller.1 MMENUN#3052 MbN: Select the desired setting. aMSAVEN a MOFFNSelecting “Greeting only”You can select “Greeting only” which setsthe unit to announce a greeting message tocallers but not record messages.Select “Greeting only” in step 2 on“Caller’s recording time”, page 27.For assistance, visit www.panasonic.ca/english/support 27Answering SystemTGD39xC_(en)_ver021.pdf 27 2016/01/25 15:56:52