Panasonic KX-TGF350 Operating Instructions Manual

Also see for KX-TG572SK: Operating instructions Service manual Operating instructions Operating instructions

test its sensitivity. Check the connection if youare diverting the baby monitor to an outside line.R This feature should not be used as a substitutefor a medical or caregiver’s supervision. It is thecaregiver’s responsibility to stay close enoughto handle any eventuality.Note:R If the unit is connected to a PBX system, youcannot set the baby monitor.R During the monitoring mode, batteryconsumption is faster than usual. Werecommend leaving the monitored handset oncharger.R The monitored handset never rings while it isbeing monitoring. If the base unit is placed nearthe monitored handset, we recommend turningoff the base unit ringer volume (page 29).Setting the baby monitorPerform the setting operation with the handset tobe monitored (for example, the handset placed ina baby’s room).To monitor with a unitThe internal baby monitor feature is only available:– between handsets– between a handset and the base unitHandset1 MMENUN#2682 MbN: “On” a MSELECTN3 MbN: Select the desired unit’s number tomonitor with. a MSAVENR “Baby monitor” will be displayed.R The registered unit’s name/number isdisplayed.Note:R When this feature is on, another handset or thebase unit can hear the monitored handset bymaking an intercom call.To monitor from an outside lineIf you enable this feature, the unit will call apre-programmed phone number when the handsetdetects sound. After you answer the call, you canlisten in on the room where the handset is located.Handsetn From the phonebook:1 MMENUN#2682 MbN: “On” a MSELECTN3 MbN: Select “Outgoing call” to monitorfrom an outside line. a MEDITN a MADDN4 MbN: “Phonebook” a MSELECTN5 MbN: Select the phonebook entry. a MSAVENR “Baby monitor” will be displayed.Note:R If you edit a phonebook entry which is assignedfor monitoring, the edited entry does not transferto the monitor.n By entering phone numbers:1 MMENUN#2682 MbN: “On” a MSELECTN3 MbN: Select “Outgoing call” to monitorfrom an outside line. a MEDITN a MADDN4 MbN: “Manual” a MSELECTN5 Enter the desired name. a MOKN6 Enter the desired number. a MOKN aMSELECTNR “Baby monitor” will be displayed.Note:R The registered name/number is displayed.Turning off the baby monitorThe monitored handset cannot be used while babymonitor is set to “On”.Handset1 Press MMENUN on the handset beingmonitored.2 MbN: “On/Off” a MSELECTN3 MbN: “Off” a MSELECTN a MOFFNEditing an outside monitoring numberHandset1 Press MMENUN on the handset beingmonitored.2 MbN: “On/Off” a MSELECTN3 MbN: “On” a MSELECTN4 MbN: Select the outside line. a MEDITN34 For assistance, please visit www.panasonic.com/supportProgrammingTGF35x(en)_1205_ver041.pdf 34 2014/12/05 21:38:32