Cyrillic character table ( )z y1 2 3 4 5 6 7 8 9Error messagesDisplay message Cause/solutionBase no powerorNo link to base.Reconnect mainbase AC adaptor.R Confirm the base unit’s AC adaptor is connected to the unitand the power outlet correctly.R The handset has lost communication with the base unit. Movecloser to the base unit and try again.R Unplug the base unit’s AC adaptor to reset the unit.Reconnect the adaptor and try again.R The handset’s registration may have been cancelled.Re-register the handset (page 35).CheckPhone LineR The supplied telephone line cord has not been connected yetor not connected properly. Check the connections (page 11).Error R Recording was too short. Try again.Memory Full R The phonebook memory is full. Erase unwanted entries(page 21).R The call block list memory is full. Erase unwanted entries(page 32).R The maximum number of base units (4) is already registeredto the handset. Cancel unused base unit registrations fromthe handset (page 36).Userechargeablebattery.R A wrong type of battery such as alkaline or manganese wasinserted. Use only the rechargeable Ni-MH batteries noted onpage 4, 8.You must firstsubscribeto Caller ID.R You must subscribe to a Caller ID service. Once you receivecaller information after subscribing to a Caller ID service, thismessage will not be displayed.TroubleshootingIf you still have difficulties after following the instructions in this section, disconnect the base unit’sAC adaptor and turn off the handset, then reconnect the base unit’s AC adaptor and turn on thehandset.Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333 49Useful InformationTGJ32xE(en)_0305_ver011.pdf 49 2015/03/05 14:31:41