Programmable SettingsFor assistance, please visit http://www.panasonic.com/phonehelp 35Caller ID number auto editYou can turn the Caller ID number autoedit feature on or off.1 {MENU} (center of joystick) i h i{SELECT}2 “Caller ID edit” i {SELECT}3 Select the desired setting. (Default:“On”) i {SAVE} i {OFF}Setting telephone lineLine selectionThe line selection mode determines whichline is selected when you press {C}.– “Auto”: When making a call, line 1 isselected. If that line is unavailable, line 2is selected. When answering a call, theringing line is selected.– “Line1”: Line 1 is selected.– “Line2”: Line 2 is selected.1 {MENU} (center of joystick) i h i{SELECT}2 “Set tel line” i {SELECT}3 “Line select” i {SELECT}4 Select the desired setting. (Default:“Auto”) i {SAVE} i {OFF}Note:L You can select a line manuallyregardless of the line selection mode bypressing {LINE1} or {LINE2}.Dialing modeIf you cannot make calls, change thissetting depending on your telephone lineservice.“Tone”: For tone dial service.“Pulse”: For rotary pulse dial service.L You only need to program this settingonce, using either the handset or baseunit.1 {MENU} (center of joystick) i h i{SELECT}2 “Set tel line” i {SELECT}3 “Set dial mode” i {SELECT}4 Select the desired setting. (Default:“Tone”) i {SAVE} i {OFF}Flash timeThe flash time depends on your telephoneexchange or host PBX.L You only need to program this settingonce, using either the handset or baseunit.Important:L The setting should stay at 700 ms unlesspressing {FLASH} fails to pick up theCall Waiting call.1 {MENU} (center of joystick) i h i{SELECT}2 “Set tel line” i {SELECT}3 “Set flash time” i {SELECT}4 Select the desired line.5 Select the desired setting. (Default:“700ms”) i {SAVE} i {OFF}Note:L If the base unit is connected via a PBX,certain PBX functions (call transferring,etc.) may not work correctly. Consultyour PBX supplier for the correct setting.