Panasonic KX-TVM200E Service Manual

Contents

3.7. FITTING A PLUG TO THE MAINS LEAD (KX-TVM200E)This appliance is supplied with a moulded three pin mains plug for your safety and convenience.A 5 amp fuse is fitted in this plug. Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 5amps and that it is approved by ASTA or BSI to BS1362.Check for ASTA mark or the BSI mark on the body of the fuse.If the plug contains a removable fuse cover you must ensure that it is refitted when the fuse is replaced.If you lose the fuse cover the plug must not be used until a replacement cover is obtained.A replacement fuse cover can be purchased from your local Panasonic dialer.IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET OUTLET IN YOUR HOME THEN THE FUSE SHOULDBE REMOVED AND THE PLUG CUT OFF AND DISPOSED OF SAFELY.THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF THE CUT OFF PLUG IS INSERTED INTO ANY 13 AMP SOCKET.If a new plug is to be fitted please observe the wiring code as shown below.If in any doubt please consult a qualified electrician.WARNING:THIS APPLIANCE MUST BE EARTHED.IMPORTANT:The wires in this mains lead are coloured in accordance with the following code:Green-and-Yellow: EarthBlue: NeutralBrown: LiveAs the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying theterminals in your plug, proceed as follows.The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the plug which is marked with the letterE or by the Earth symbol or coloured GREEN or GREEN-AND-YELLOW.The wire which is coloured BLUE must be connected to the terminal in the plug which is marked with the letter N or colouredBLACK.The wire which s coloured BROWN must be connected to the terminal in the plug which is marked with letter L or coloured RED.How to replace the fuse: Open the fuse compartment with a screwdriver and replace the fuse and fuse cover.11KX-TVM200E / KX-TVM200NE