Panasonic KX-TVP50 Subscriber's Manual

Also see for KX-TVP50: Installation manual Getting started Installation manual Getting started Operating instructions

Panasonic KX-TVP50 Subscriber's Manual Manual pdf 42 page image

Glossary42Called Party ID(Sometimes referred to as Follow-On ID) Allows the PBX to dial extra digits to bring thecaller directly to a specified mailbox, rather than to the General Delivery Mailbox.Caller ID Call Routing(Available with APT/DPT Integration only.) The VPS automatically sends calls frompre-assigned Caller ID numbers to the desired extension, mailbox (including SystemGroup Distribution List) or Custom Service.Caller Name Announcement (System/Personal)(Available with APT/DPT Integration only.) The VPS announces pre-recorded Caller IDcaller’s names when: (1) extension users listen to messages from pre-assignednumbers left in the their mailboxes, (2) the VPS transfers calls from pre-assignednumbers to the users (Caller ID Screening), and (3) the VPS pages the users byintercom (Intercom Paging).If the same Caller ID number is programmed for both system and personal caller nameannouncements, the VPS will use the personal caller name.Company GreetingUp to 32 Company Greetings can be recorded to greet callers. One (or SystemGreeting or none) can be selected for each Day, Night, Lunch, Break, and Holidayservice on a port basis and trunk (outside line) basis.Company NameThis is played by the VPS to the intended receiver of an External Delivery Messagewhen she does not enter the password (if required) correctly. This helps her to realisewhere the call came from.Covering ExtensionThis can be a destination for Incomplete Call Handling Service. This can also beaccessed by pressing [0] while a Personal Greeting is being played, or while a calleris leaving a message.Custom Service SettingAllows one-touch access to extensions, other custom service menus, fax machine,mailboxes, etc. A greeting can be recorded for each of the 100 menus to give verbaldirections to the non-subscribers.Default SettingA parameter defined for the system at the factory which can be changed throughsystem programming by the System Administrator or the System Manager.