INTEGRATING THE VPS WITH PANASONIC KX-T PHONE SYSTEMSInstallation Manual 713.3.2 KX-TA series Programming for Inband Integration via theManager's ExtensionNoteIf your PBX is the KX-TA1232, please refer to the procedure described in 3.3.4 KX-TD816, KX-TD1232, KX-TA1232 and KX-TD308 Programming for Inband Integration viathe Manager's Extension or 3.3.5 KX-TD816, KX-TD1232, and KX-TA1232 Programmingfor Inband Integration via the Operating and Maintenance Tool for programming.1. Enable System Program [102] for each extension connected to the VPS. Jack 07, or jacks07 and 08 can be assigned for the VPS as the Voice Mail port.This parameter is used to tell the KX-TA series which extensions are connected to the VPS.Ports with this parameter enabled can receive Follow-on ID and touchtone call statusSignaling (busy, answered, disconnect, etc.) if the Voice Mail integration and TouchtoneIntegration features are also enabled.2. Enable System Program [103] to turn on Touchtone Integration. On extensions with theVoice Mail port parameter enabled, the KX-TA series can send codes (touchtones) toindicate call states; this increases VPS efficiency. Codes apply to all transferred calls;outside calls only indicate disconnect (provided the KX-TA series is programmed for CPCDetection, and the Central Office sends the CPC signal). Refer to the Table 15 in Section3.2.4 PBX Interface Parameters.3. Put all extensions connected to the VPS into 1 extension group using System Program[600].Call WaitingSequence* N/A N/A 1 N/A N/A 1 1Release Sequencefor Call Waiting* N/A N/A F N/A N/A F F* Check with manufacturer.N/A Not Available(A) Adding "A" for "answer" to the operator and extension transfer eliminates the message:"You have a call" when the AA transfers a call. The VPS disconnects after line isanswered. Adding "D" for "disconnect" creates a blind transfer.Table 17PBX Type OtherManufacturers T308 T616 T1232/TA series T96 T336TD816/TD1232/TA1232/TD308TD500
