3. Select "Register H/S" and then press .Register H/SCancel BaseSelect BaseSystem LockChange PIN4. Select a base number and then press .Note• You can register four separate bases on your S-PS.Register H/SBase 1Base 2Base 3Base 45. Hold down until "Please wait…" is displayed.6. When registration has completed, "Registered" will be displayed.Note• You can register multiple S-PSs continuously. However, PS Registration mode will terminate if noregistrations are detected within 2 minutes. All SIP-CSs controlled by the Super Master CS will enterPS Registration mode at the same time as the Super Master CS. You can register an S-PS to any ofthe SIP-CSs.• When registering multiple S-PSs, perform the registration procedure on each S-PS individually.Performing the registration procedure on multiple S-PSs at the same time may result in an error. In thiscase, reperform the registration procedure.• After registering S-PSs, the Web port will be closed (® see Opening the Web Port in 2.1.1 BeforeAccessing the Web User Interface).• After registering S-PSs, S-PS firmware update may start automatically. During the firmware update,the S-PS may reboot up to 3 times. Therefore, you should not remove the battery/batteries of the S-PS.Document Version 2013-03 Administrator Guide 2455.1 PS Registration from Web User Interface
