Advanced (Recording pictures)- 122 -When [AUTO REGISTRATION] is set to [ON] in step 3 of “Change the information for aregistered person” (P121) while [FACE RECOG.] in the [REC] Mode menu is set to [ON],the registration screen will display automatically after taking a picture of a face that has ahigh number of appearances.• Registration screen is displayed after approximately 3 pictures. (It is not counted when Burstand Auto Bracket/Colour Bracket is set.)• It may be extremely hard to recognise only with [AUTO REGISTRATION], so register the faceimages with [FACE RECOG.] in the [REC] Mode menu beforehand.∫ Registering from the automatic registration screen1 Press 3 to select [YES] and then press [MENU/SET].• If there are no registered persons, proceed to step 3.• Selection screen is displayed again when [NO] is selected, andwhen [YES] is selected with 3, [AUTO REGISTRATION] will beset to [OFF].2 Press 3/4 to select [NEW PERSON] or[ADDITIONAL IMAGE] and then press [MENU/SET].• After additionally registering or changing a face image, the screen returns automatically tothe recording screen.3 Use the operation in Step 5 and following in “Registering face image of newperson”.Note• If the registration screen will not display, it may display easier by recording in the sameconditions or with the same expressions.• If a face is not recognised even though it is registered, it will make the recognition easier byregistering the person again using the [FACE RECOG.] in the [REC] Mode menu in thatenvironment.• If the registration screen is displayed for the person that is already registered, it will make therecognition easier by additionally registering.• It may make recognition harder when a picture recorded with flash is registered.Auto RegistrationItem Description of settings[NEW PERSON] • A list of registered people is displayed when there are 6 peoplealready registered. Select the person to be replaced.[ADDITIONAL IMAGE]To additionally register a face image for a registered person.Press 3/4/2/1 to select the person to whom you wishadd the picture, and then press [MENU/SET].• If 3 images have already been registered, the picturereplacement screen will appear. In this case, select the pictureyou wish to replace.
