Panasonic Lumix DMC-FS9EB Service Manual

113.4.2. INITIAL SETTINGS:After replacing the MAIN P.C.B., be sure to perform the initial settings after achieving the adjustment by ordering the following pro-cedure in accordance with model suffix of the unit.1. IMPORTANT NOTICE:Before proceeding Initial settings, be sure to read the following CAUTIONS.2. PROCEDURES:• Precautions: Read the above "CAUTION 1" and "CAUTION 2", carefully.• Preparation:1. Attach the Battery or AC Adaptor with a DC coupler to the unit.(Since this unit has built-in memory, it can be performed without inserting SD memory card.)2. Set the recording mode to the [ NORMAL PICTURE ] mode.(Press the [ MODE ] button and select the [ NORMAL PICTURE ] by pressing the “[ UP ] and [ DOWN ] of Cursor buttons”,then press the [ MENU/SET ] button.)NOTE:If the unit is other than [ NORMAL PICTURE ] mode, it does not display the initial settings menu.• Step 1. The temporary cancellation of “INITIAL SETTINGS”:Set the [ REC ]/[ PLAYBACK ] selector switch to “[ REC ] (Camera mark)”.While keep pressing “[ UP ] of Cursor button” and [ iA ] button simultaneously, turn the Power on.• Step 2. The cancellation of “INITIAL SETTINGS”:Set the [ REC ]/[ PLAYBACK ] selector switch to “[ PLAYBACK ]”.Press “[ UP ] of Cursor button” and [ iA ] button simultaneously, then turn the Power off.• Step 3. Turn the Power on:Set the [ REC ]/[ PLAYBACK ] selector switch to “[ REC ] (Camera mark)”, and then turn the Power on.• Step 4. Display the INITIAL SETTING:While keep pressing [ MENU/SET ] and “[ RIGHT ] of Cursor buttons” simultaneously, turn the Power off.The "INITIAL SETTINGS" menu is displayed.There are two kinds of “INITIAL SETTINGS” menu form as follows: