Panasonic Lumix DMC-FS9EB Service Manual

19Important notice about "Error Code List"1) About "*" indication:The third digit from the left is different as follows.- In case of 0 (example: 18001000)When the third digit from the left shows "0", this error occurred under the condition of INITIAL SETTINGS has beencompleted.It means that this error is occurred basically at user side.- In case of 8 (example: 18801000)When the third digit from the left shows "8", this error occurred under the condition of INITIAL SETTINGS has beenreleased.(Example; Factory assembling-line before unit shipment, Service mode etc.)It means that this error is occurred at service side.2) About "?" indication: ("18*0 0?01" to "18*0 0?50"):The third digit from the right shows one of the hexadecimal ("0" to "F") character.• 4. How to exit from Error Code display mode:Simply, turn the power off. (Since Error code display mode is executed under the condition of temporary cancellation of "INI-TIAL SETTINGS", it wake up with normal condition when turn off the power.)NOTE:The error code can not be initialized.6.2. ICS (Indication of additional Camera Settings when picture was taken)function1. General descriptionThis unit is equipped with ICS (ICS: Indication of additional Camera Settings when picture was taken) function by playing backthe concerned picture on the LCD display.(This function is achieved by utilizing "maker note" data stored in Exif data area of recorded picture file.)To proceed failure diagnosis, use this ICS function together with "displaying the recorded picture with picture information "function.NOTE:• The ICS function operates with a picture which is only taken with the same model. (It may not be displayed when the picturewas taken with other model.)• Since Exif data is not available after the picture is edited by PC, the ICS function may not be activated.2. How to displayThe ICS data is displayed by ordering the following procedure:• Preparation:1. Attach the Battery or AC Adaptor with a DC coupler to the unit.NOTE:It is not a matter or the setting condition of Recording mode (such as “normal picture/scene/motion picture” mode) to displaythe ICS data.• Step 1. The temporary cancellation of "INITIAL SETTINGS":Set the [ REC ]/[ PLAYBACK ] selector switch to “ [ REC ] (Camera mark)”.While keep pressing “[ UP ] of Cursor button” and [ iA ] button simultaneously, turn the Power on.• Step 2. Execute the ICS display mode:Set the [ REC ]/[ PLAYBACK ] selector switch to [ PLAYBACK ].Select the concerned picture by pressing the "[ LEFT ] and [ RIGHT ] of Cursor button".Press the "[ LEFT ] of Cursor button", [ MENU/SET ] button and [ iA ] button simultaneously.Press the [ DISPLAY ] button, 3 times.The display condition is changed as shown below when the [ DISPLAY ] button is pressed.Code display → Code + Picture display (1) → Code + Picture display (2) → ICS display → Code display .....