Panasonic MultiCam PV-DV202-K Operating Instructions Manual

Contents

Panasonic MultiCam PV-DV202-K Operating Instructions Manual Manual pdf 48 page image

48Editing Features3, 4PLAY3, 4, 5PAUSE3, 4PLAY6STOP4RECHigh quality digital-to-digital copying canbe accomplished if both Palmcordersincorporate the DV Input/Output (i.LINK)Connector (DV Interface cable (i.LINK) isnot supplied).1 Insert a pre-recorded tape into thesource (playing) Palmcorder, and setPOWER to VCR.2 Insert a blank tape with the recordtab closed into the target (recording)Palmcorder and set POWER to VCR.• For PV-DV402-K users:To use the Recording Palmcorder,first set to AV-JACK “OUT/PHONES”in the VCR Mode Menu.(Menu OSD: p. 104)3 Press (PLAY) on the sourcePalmcorder. When the tape reachesthe point from which you want to startdubbing, press (PAUSE).4 Hold down REC and press (PLAY)on the target (recording) Palmcorder.Press (PAUSE) to pause the tape atthe starting point of the dub.5 Simultaneously, press (PAUSE) onboth units to begin dubbing.6 Press (STOP) on the recordingunit, and then press (STOP) on theplaying unit to end dubbing.• When two Palmcorders are used fordubbing, it is recommended that theRemote Control VCR1 or VCR2 setting beused to avoid improper-operation.• When two Palmcorders are connectedusing the DV Interface cable (i.LINK) (notsupplied), a Video Editing Controllercannot be used.CAUTION:Unauthorized exchanging and/orcopying of copyrighted recordings maybe copyright infringement.Source (Playing)PalmcorderRecordingPalmcorderDV InterfaceCable (i.LINK)(optional)(PV-DDC9-K)DV Input/Output(i.LINK) ConnectorCopying from DigitalEquipment (dubbing)Note3, 4, 5PAUSEBefore you begin• Connect both Palmcorders to theirpower sources.• Connect the two Palmcorders using theDV Interface cable (i.LINK)(4-pin to 4-pin).• Turn both Palmcorders ON.6STOP4RECNoteDV202_402-K.p 44-48.p65 2003/06/12, 10:1548