List of setting menus (continued)The underlined settings are the factory mode settings.TIMECODE SETUP screen (continued)Item Description of settingsEXT UB REGEN This is used to select whether to clone the incoming user's bit information, or generatenew user's bit information.ON:The signals are recorded using the user’s bit of the external input signal selected onthe setting menu “INPUT SELECT”.OFF:The signals are recorded using the user’s bit selected on the setting menu “UB MODE”.When this item has been set to ON, it takes priority over the setting menu “UB MODE”.UB MODE This is used to set what is to be recorded as the user’s bit. “OFF” must be selected forthe “EXT UB REGEN” item setting. (Page 66)USER:The user information is recorded.TIME:The time of the recording is recorded.DATE:The date/time of the recording are recorded.TCG:The value generated by the time code generator is recorded.FRM. RATE:The information of the frame rate after frame conversion is recorded.a b c da: Information on the verification of the user’s bit valueb: Frame sequence number•“F” is displayed in 60i/30p or 50i/25p mode.c: Frame rate information• Frame rate (60, 30, 24, 50 or 25)• I/P identification information• Conversion information• Frame rate factord: Recording control information• Updated frame information• REC START/STOP informationWhen playing back native recorded clipsTo set the SDI or 1394 output user’s bit as the frame rate information, selectFRM. RATE for this setting, and play back the clips.UB PRESET This is used to set the user’s bit. “OFF” must be selected for the “EXT UB REGEN”item setting and “USER” must be selected for the “UB MODE” item setting. (Page 66)
