Panasonic P2HD AG-HPG20 Operating Instructions Manual

Contents

The underlined settings are the factory mode settings. MenuPLAYBACK FUNCTIONS screen (continued)Item Description of settingsSDI IN LOCK This is used to select whether the P2 playback output signal is locked (synchronized)to the SDI input signals.INT:It is not locked (synchronized).INPUT:When the SDI input signal is present, it is locked (synchronized) to the input signal.It is not locked (synchronized) when the input signal is not present.When SDI is set on the setting menu “INPUT SELECT” and the same SDI input signalas the one set on the setting menu “SYS FORMAT” is input, the output signal islocked (synchronized) to the SDI input signal in EE/recording condition regardless ofthe setting for the setting menu “SDI IN LOCK”.SPEED MAX This is used to set the maximum speed of the variable-speed playback and rapidforward/rapid reverse playback.X: 32x speedX60: 60x speedX100: 100x speedSEEK POS When using the navigation buttons to jump to the next clip, this menu item controlswhether the unit will jump to the beginning of the next clip, or to the next text memoposition.CLIP: The beginning of the clipCLIP&TMEMO: The beginning of the clip and text memo setting pointAV OUT SETUP screenItem Description of settingsSDI SEL This is used to set the video signal output from HD/SD-SDI OUT connector.(When the 59.94 Hz system format is set)AUTO:The output is automatically switched according to the clip format during playback.The output is automatically switched according to the setting menu “SYS FORMAT”during situations other than playback.100i: 1080/59.94i0P: 720/59.94p0i: 480/59.94i(When the 50 Hz system format is set)AUTO:The output is automatically switched according to the clip format during playback.The output is automatically switched according to the setting menu “SYS FORMAT”during situations other than playback.100i: 1080/50i0P: 720/50p56i: 576/50iSDI OUT This is used to set the SDI output.ON: SDI signals are output.OFF: SDI signals are not output.SDI EDH This is used to set whether to superimpose error detection handling (EDH) when SD-SDI signals are output.ON: EDH is superimposed.OFF: EDH is not superimposed.