Panasonic PT-CW230E Operating Instructions Manual

Also see for PT-CW230E: Operating instructions Service manual

Contents

Powering ON/OFF28 - ENGLISHBasic OperationPress the <1 ) > button on the control panel orthe remote control, and Power off? appears onthe screen.Press the <2 ) > button on the control panel orthe remote control again to turn off the projector.The indicator starts toblink red, and the cooling fans keep running.At this time, you can unplug the AC power cordeven if the fans are still running.When the projector has cooled down enough, the3 ) indicator stops blinkingand you can turn on the projector.NoteDo not put the projector in a case before the projector iszcooled enough.While thez indicator is blinking,the lamp is being cooled down and the projector cannotbe turned on. Wait until the indicator stops blinking to turn on the projector again.The projector can be turned on after thez STANDBY(R)> indicator turns red. The waiting timeto restart will be shortened when the normal power-offprocessing for fan cooling is completed, compared withthe time the AC power cord is immediately unpluggedafter the power-off.To protect the component parts inside the projector, thezfans normally start running again in approximately 40seconds after turning off the projector. This is NORMALoperation and not a malfunction.J Direct Power Off functionYou can disconnect the power cord from the walloutlet or turn off the breaker even during projectionwithout pressing the < > button.NoteWhen using the Direct power Off function, you canznot restart the projector immediately after the power isdisconnected. The lamp remains high temperature andneeds to be cooled, so it sometimes takes longer timethan usual for the lamp to light up again.Turning Off the ProjectorPower off? disappears after 4 seconds.