Panasonic PT-CW230E Operating Instructions Manual

Also see for PT-CW230E: Operating instructions Service manual

Contents

Projecting30 - ENGLISHBasic OperationFor Viewing 3D ContentsTo view 3D images, you need to prepare at least the 3D active shutter glasses, 3D content and 3D reproducingequipment. For example, as for computer, when transmitting 3D signals from a computer to the projector, youalso need to install the graphic card which has the capability to sequentially output the 3D frames at 120Hz andsoftware in the computer. The 3D signal type which the projector can accept is frame sequential only. Other 3Dsignal types such as frame packing and side-by-side are not supported.As for 3D glasses, DLP Link format and IR emitter format are compatible with this projector. Compatibility withany other 3D glasses than the 2 types 3D glasses is not guaranteed.In a situation of using NVIDIA 3D glasses, NVIDIA IR emitter, and a computer which NVIDIA graphics card isinstalled, when you want to view NVIDIA-compatible 3D contents, please set to NVIDIA 3D VISION mode.AttentionCOMPUTER 2 IN/MONITOR OUT terminal is not supported NVIDIA 3D VISION. Please input the image signals tozCOMPUTER 1 IN/COMPONENT IN or HDMI terminal.Using 3D Glasses with DLP Link compatibleJWhen using DLP Link compatible glasses, follow these steps:Turn on the projector and the 3D glasses.1 )Wear the 3D glasses and press the 3D button on the remote control to activate 3D Display function.2 )When 3D mode is in On, 3D indicator turns blue.If you see a discrete or overlapping image, 3D Sync Invert function enables you to get the correct image.3 )Press the 3D button to switch 3D Sync signal from among "3D Off", "3D (Sync 1)", "3D (Sync 2)" or "3DVISION".Note3D setting can also be selected from the menu.z (Æpage 52)Using 3D Glasses with IR wireless emitterJWhen using IR emitter system, follow these steps:Turn off the projector.1 )Connect the sync cable for the IR emitter to 3D SYNC OUT terminal of the projector.2 )Turn on the projector, the IR emitter and the stereoscopic wireless LCD glasses.3 )Wear the 3D glasses and press the 3D button on the remote control to activate 3D Display function.4 )NoteIf you see a discrete or overlapping image, press the 3D button to switch 3D Sync signal from among "3D Off", "3D (Sync 1)",z"3D (Sync 2)" or "3D VISION".You can also invert the sync signal by using the switch on the IR emitter.zAttentionBefore viewing 3D contents, please read "Precaution for use". (z Æpages 12-13)