Panasonic PT-EZ590 Operating Instructions Manual

Also see for PT-EW550: Operating instructions

Contents

Panasonic PT-EZ590 Operating Instructions Manual Manual pdf 51 page image

Chapter 3 Basic Operations — ProjectingENGLISH - 51ProjectingCheck the attachment of the projection lens (x page 38), external device connection (x page 40), powercord connection (x page 45), and switch on the projector (x page 46) to start projecting. Select the imagefor projection, and adjust appearance of the projected image.Selecting the input signalRemote controlControl panelThe input for projection can be switched. Method to switch the input is as follows.f Press the input selection buttons on the remote control and directly specify the input to project.f Press the button on the control panel to display the input selection screen and select theinput to project from the list.Switching the input directly via remote controlThe input for projection can be switched directly by pressing the input selection button on the remote control.1) Press the input selection (, , *1 , ,

buttons.f Switches the input, the input guide of the selected input terminal displayed on the top right of the projectionscreen. Switches the input to HDMI1. The image of the signal being input in the terminal isprojected. Switches the input to HDMI2. The image of the signal being input in the terminal isprojected. *1 Switches the input to DIGITAL LINK. The image of the signal being input in the terminal is projected.Switches the input to RGB1 or RGB2. If one input is already selected, it will be switched to the otherinput. The image of the signal being input in the terminal or the terminal isprojected.

Switches the input to VIDEO. The image of the signal being input in the

projected. Switches the input to NETWORK.*1 button is disabled for PT-EW550 and PT-EX520.Attentionf Images may not be projected properly depending on the external device, or the Blu-ray disc or DVD disc, to be played back. Set the [PICTURE]menu → [RGB/YCBCR ]/[RGB/YPBPR ]. (x page 70)f Confirm the aspect ratio of the projection screen and the image, and switch to an optimum aspect ratio from the [POSITION] menu →[ASPECT]. (x page 78)Notef (Only for PT-EZ590, PT-EW650 and PT-EX620)When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the LAN> terminal, the input on the DIGITAL LINK output supported device changes each time the button is pressed. The inputcan also be changed using the RS-232C control command.For twisted-pair-cable transmitters of other manufacturers, switch the input on the projector to DIGITAL LINK, and then switch the input onthe twisted-pair-cable transmitter.f Configure [RGB1 INPUT SETTING] of the [DISPLAY OPTION] menu → [RGB IN] (x page 82) to match the signal to be input to the terminal.