61Using WebBrowser (cont.)Enabling JavaScriptIf JavaScript has been set to disable, enable it.2 Select [Security] and set the security level to [Default Level], or select [CustomLevel] and check the [Enable] checkbox under [Active scripting].Open window.Click [Start] ĺ [Control Panel] ĺ [Network and Internet Connections] ĺ [Internet Option].1Accessing from the WebBrowser1 Click [ ] on the launcher.Or start up the WebBrowser, and enter the IP address set by the projector.The WebBrowser starts up and the authentication window appears.2 Enter the user name and the password.3 Click [OK]. window appears. (Next page)• The default user name and password settings are as follows.User name: user1Password: (The password is not set.)• Password used in this page is for accessing the web control window. (See page 67)This password is different from the password set in page 57 for accessing a projector.• The system locks for several minutes if an incorrect password is entered three times in succession.• No password is set at time of purchase or after default settings are restored. Be sure to set a password at such times.• Make sure the password is as hard to guess as possible.• Change the password periodically.• If you forget the password, perform [INITIALIZE] using the network menu of the projector (See page 59) and set a passwordagain using the window on the WebBrowser. (See page 67)• Matsushita Electric Industrial Co., Ltd. and its affiliated companies never directly ask customers for their password.Do not give out your password even if directly asked by a third-party representing themselves as Matsushita Electric IndustrialCo., Ltd.• The top window may not appear depending on the WebBrowser. In this case start up WebBrowser again, or press the [Ctrl] +[R] keys for example to update the screen.• Connection cannot be made while the WebBrowser is set to dial-up network. Cancel the dial-up network setting.• It may take some moments for WebBrowser to start up.
