Basic OperationRemote control operationENGLISH - 28You can switch the input method manually bypressing the COMPUTER, NETWORK andVIDEO buttons. Press the required buttonseveral times or I H to cycle through theinput methods as follows. The actualprojected image will be changed in a while.The graphical guidance will be displayed on the upperright of the projected image and you can confirm theselected input method which is highlighted in yellow. See“INPUT GUIDE” on page 40.J Pressing the COMPUTER buttonJ Pressing the NETWORK buttonOnly for the network connection operation. See CD-ROM contents for more detailed information.J Pressing the VIDEO buttonJ Pressing the INPUT SELECTbutton on the projectorYou can enlarge the projected image down to a centred area for emphasizing within the range of 1x to 2x.Q Enlarging the image1. Press the DIGITAL ZOOM +/- button once.The centred area of the image will then be enlargedto 1.5x.2. Adjust the image size by pressing the DIGITALZOOM +/- button.The image size will be changed in steps of 0.1.Q Shifting the centre pointPress F G I H to shift the centre point.Switching the input signalNOTE:• If you select an unplugged input method, the guidancewill blink on and off several times.• See “List of compatible signals” on page 54.• See “Connections” on page 21.COMPUTER1 H COMPUTER2F GDVINOTE:• Only when the COMPUTER2 SELECT is set to INPUT,the COMPUTER2 is selectable.VIDEO IH S-VIDEOCOMPUTER1 H COMPUTER2F GDVI S-VIDEOF GNETWORK I VIDEOEnlarging the centred areaNOTE:• When the COMPUTER signal is projected, the enlargement range will be changed to 1x to 3x. When the FRAME LOCKin POSITION menu is set to ON, the enlargement range is 1x to 2x. See “FRAME LOCK” on page 39.• When the input signal is changed while the DIGITAL ZOOM is activated, the DIGITAL ZOOM will be cancelled.• While DIGITAL ZOOM is activated, FREEZE is not available.