Panasonic PT-L735E Operating Instructions Manual

Also see for PT-L735E: Operating instructions

E NGLISH -39 Adjustments and settings38-ENGLISHCONTRASTThis adjusts the contrast of thepicture. Press the H button to makethe picture brighter, and press theI button to make the picturedarker. (Adjust the BRIGHT settingfirst if required before adjusting theCONTRAST setting.)BRIGHTThis adjusts the darker areas (blackareas) in the picture. Press the Hbutton if dark areas are too solid (forexample, if hair is difficult to see), andpress the I button if black areas aretoo light (grey rather than black).COLOR(S-VIDEO/VIDEO/YPB P R only)Press the H button to make thecolour more vivid in tone, and pressthe I button to make the colourmore pastel in tone.TINT(NTSC/NTSC 4.43/YPBPR only)This adjusts the flesh tones in thepicture. Press the H button to makeflesh tones more greenish, andpress the I button to make theflesh tones more reddish.SHARPNESSPress the H button to make the picturedetails sharper, and press the I buttonto make the picture details softer.Colour Hue Setting(COLOR TEMP.)This is used to adjust the whiteareas of the picture if they appearbluish or reddish.Noise Reduction (NR)(When S-VIDEO/VIDEO/YP BPRsignals are being input)If the signal is of such poor qualitythat picture interference appears, youcan suppress this interference byadjusting the NR (Noise Reduction).To strengthen the effect, press the Hbutton. To turn it off , set to “0” bypressing the I button.WHITE BALANCE R/G/B(RGB only)This is used to adjust the whiteareas of the picture if they appearcolourised. Press the I button tomake the selected colour lighter.Press the H button to make theselected colour stronger.TV-SYSTEM(S-VIDEO/VIDEO only)AUTO1The projector automaticallydistinguishes between NTSC/NTSC4.43/PAL/PAL60/SECAM signals.AUTO2The projector automaticallydistinguishes between NTSC/PAL-M/PAL-N signals.STANDARDHIGHLOWAUTO1AUTO2NTSCNTSC4.43PALPAL-MPAL-NSECAMProjecting sRGB-compatible picturessRGB is an international colourreproduction standard (IEC61966-2-1) established by the InternationalElectrotechnical Commission (IEC).If you would like the colours insRGB-compatible pictures to bereproduced more faithfully, makethe following settings.## Press the FF or GG button toselect “PICTURE MODE”, andthen use the II or HH button toselect “NATURAL”.$$ Press the FF or GG button toselect “COLOR TEMP.”, andthen use the II or HH button toselect “STANDARD”.%% Press the STD (standard)button on the remote controlunit.&& Select the LAMP POWER itemin the OPTION menu bypressing the FF or GG buttonsand set to “HIGH” by pressingthe II or HH buttons.NOTE:B sRGB is only enabled whenRGB signals are being input .NOTE:B This should normally be set to“AUTO1” or “AUTO2”. If thesignal is of such poor qualitythat the correct format cannotbe automatically distinguished,change the setting manually tothe required TV system.