E NGLISH-47 Adjustments and settingsDESK/CEILINGThis setting should be changed inaccordance with the projectorsetting-up method.(Refer to page 18.)DESKWhen the projector is placed on adesk or similar.CEILINGWhen the projector is suspendedfrom a ceiling using the ceilingbracket (sold separately).FAN CONTROLSet “FAN CONTROL” to “HIGH”,when using this projector at highelevations (above 1 400 m) only.LAMP POWERThis setting changes the lampbrightness. When set to “LOW”, theluminance of the lamp is reduced,but the projector uses less power,and the operating noise is alsoreduced. This can help to extendthe lamp’s operating life. If using theprojector in small rooms where highluminance is not required, it isrecommended that you set the“LAMP POWER” to “LOW”.LAMP RUNTIMEThis setting displays the usage timefor the lamp unit which is currentlybeing used. When replacing thelamp unit, follow the instructions onpage 56, and reset “LAMPRUNTIME” to “0”.FUNC 1This assigns a function to theFUNC1 button of the ET-RM300wireless remote control unit (soldseparately).DAYLIGHTFunctions in the same way as when“DAYLIGHTVIEW” is selected fromthe “PICTURE” menu. (page 39)KEYSTONEFunctions in the same way as when“KEYSTONE” is selected from the“MAIN MENU”. (page 36)D E S K / C E I L I N G D E S K[C E I L I N GL A M P P O W E R H I G H[L O WF A N C O N T R O L S T A N D A R D[H I G HNOTE:B “LAMP POWER” cannot be setwhen no signal is being input.F U N C 1 D A Y L I G H T[K E Y S T O N ENOTE:B The lamp’s operating life variesdepending on the usageconditions (such as the “LAMPPOWER” setting and thenumber of times the power isturned on and off).