Panasonic PT-LB3U Operating Instructions Manual

Also see for PT-LB1U: Operating instructions Operating instructions Operating instructions

Panasonic PT-LB3U Operating Instructions Manual Manual pdf 23 page image

Basic operationsENGLISH  23Remote control operationYou can freeze the projected image and temporarilystop the sound, regardless of the playing condition ofthe connected device.FREEZE Press the button again to cancel it.The image is distorted momentarilywhen the projection is stopped andrestarted.STOP THE PROJECTIONTEMPORARILYYou can temporarily stop the projection and the soundfrom the projector.AVMUTE Press the button again to cancel it.SWITCH THE INPUT SIGNALYou can switch the input signal to be projected.COMPUTERCOMPUTER The options below are displayedeach time you press this button.COMPUTER1 Signal input to COMPUTER1 INterminalCOMPUTER2 Signal input to COMPUTER2 INterminalVIDEOVIDEO The options below are displayed eachtime you press this button.S-VIDEO Signal input to S-VIDEO IN terminalVIDEO Signal input to VIDEO IN terminalCAPTURE AN IMAGEYou can confirm the selected input terminal (from thegraphical input terminal guide on the upper right of thescreen), if INPUT GUIDE (DISPLAY OPTION ON-SCREEN DISPLAY menu) is set to DETAILED.( page 33)You can change the input with [].It may take some time to change the image after theinput signal is switched.NOTE:Input a compatible signal shown in the “LIST OF•COMPATIBLE SIGNALS”. ( page 50)For the input terminals,• see “Connections”. ( page 16)The input guide automatically disappears when it is left•idle.Press [INPUT SELECT] on the control panel to switch theinput in the following order. ( page 11)COMPUTER1 COMPUTER2VIDEO S-VIDEOAUTOSETUPFREEZEAVMUTECOMPUTER VIDEODEFAULT FUNCTION WIN.INDEX-DIGITAL ZOOM VOLUMESET UP THE IMAGE POSITIONAUTOMATICALLYThe projector automatically adjusts the SHIFT, DOTCLOCK and CLOCK PHASE when an RGB signal isinput.AUTOSETUPNOTE:The• SIGNAL SEARCH will be in operation when it is set toON. ( page 35)If the dot clock frequency is higher than 162 MHz,• DOTCLOCK and CLOCK PHASE can not be adjustedautomatically. ( page 30, 31)If the projected signal or image is too dark or blurred around•the edge, AUTO SETUP may stop the process beforecompleting the adjustment or adjust abnormally. Project amuch clearer or lighter image and try again.Projected imageScreen