Panasonic PT-LB75VU Operating Instructions Manual

Also see for PT-LB75VEA: Operating instructions Brochure & specs

Contents

Panasonic PT-LB75VU Operating Instructions Manual Manual pdf 31 page image

PICTURE menuSettingsENGLISH - 31DAYLIGHT VIEWYou can keep the projected image bright and vivideven in well-lit rooms where the ambient light sourcescannot be controlled, such as when a door opens orwhen window coverings fail to block out sunlight.Change setting Change settingAUTO ON OFFAUTO Automatic adjustmentON ActiveOFF DeactiveRemarksDo not cover the Ambient Luminance Sensor (z ALS)of the projector. The AUTO mode may not operatenormally.AUTOz is not available when INSTALLATION inPROJECTOR SETUP menu is set to REAR/DESKor REAR/CEILING.STILL MODEYou can reduce the vertical flicker when projecting astill image.(Available with signals of S-VIDEO/VIDEO only)Change setting Change settingOFF DeactiveON ActiveNoteYou must set toz OFF when projecting a movingimage.NOISE REDUCTIONYou can switch the automatic noise reduction systemon/off.(Available with signals of S-VIDEO/VIDEO only)Change setting Change settingOFF No noise reductionON Automatic noise reductionNoteNOISE REDUCTIONz is set active when the selectedinput signal has less noise. Applying noise reductionmay affect the image quality, if so, set to OFF.TV-SYSTEMWhen the video signal is changed, the settingswitches automatically. You can switch the settingmanually to match the video data.(Available with signals of S-VIDEO/VIDEO only)Change setting Change settingAUTO NTSC NTSC4.43SECAM PAL-N PAL-M PALNoteAUTOz mode is selected by default.When the projector is not working properly inz AUTOmode, change the setting according to each TVsystem type.RemarksAUTOz setting will automatically select the compatiblesignal from NTSC/NTSC 4.43/PAL/PAL60/PAL-M/PAL-N/SECAM.RGB/YPB PRAUTO mode is selected by default. If the image is notprojected normally in the AUTO mode, select RGB orYPB PR according to the input signal.The function becomes effective only when certainsignals below are input.(VGA60, 480i, 576i, 480p, 576p, 1 080/60i, 1 080/50i,720/60p, 720/50p)Select the signals to be input to the COMPUTER1and COMPUTER2 IN terminal.Change setting Change settingAUTO Automatic adjustmentRGB For RGB signalsYPB PR For YPBPR signals