Panasonic PT-TW330EA Operating Instructions Manual

Also see for PT-LW271U: Specifications Operating instructions Operating instructions

Contents

Panasonic PT-TW330EA Operating Instructions Manual Manual pdf 57 page image

Maintenance/replacementENGLISH - 57 MaintenanceUsed for PT-TW240EAzThe used lamp time is calculated internally in the following formula as the used time in each setting of [Normal], [Auto] and[ECO] in [Lamp power mode]:Lamp runtime = (Lamp runtime of [Normal] × 51 + Lamp runtime of [Auto] × 24 + Lamp runtime of [ECO] × 34) ÷ 51 In order to estimate the lamp life, please refer to [Lamp Hours Used (Normal)] and [Lamp Hours used (ECO)] inthe [Lamp settings] menu (Æ page 43). [Lamp Hours Used (ECO)] is a total real time under [Auto] and [ECO]lamp power modes. Please note that they are not displayed individually. Lamp use time = ([Lamp Hours Used (Normal)] × 51 + [Lamp Hours Used (ECO)] × α2) ÷ 51When setting under both [Normal] and [ECO], not using [Auto]: α2 = 34When setting under both [Normal] and [Auto], not using [ECO]: α2 = 24When setting under both [ECO] and [Auto]: 24 < α2 < 34The ratio of α2 will be smaller if the used time of [Auto] is more than that of [ECO].Replacing the Lamp unitJAttentionWhen the projector is mounted on a ceiling, do not work with your face close to the projector.zAttach the lamp unit and the lamp cover securely.zWhen you experience difficulty in installing the lamp, remove it and try again. If you use force to install the lamp, thezconnector may be damaged.Do not loosen other than designated screws.zLamp cover screwHandleLamp unit screwsLamp coverTurn off the Power by following the procedure in "Powering off the projector".1 )(Æpage 29). Remove the AC power plug from the wall outlet. Wait at least 1 hour andmake sure the lamp unit and surroundings are cool.Use a Phillips screwdriver to loosen the lamp cover screw and open the lamp cover.2 ) Open the lamp cover by pulling it slowly toward the direction of the arrow.zUse a Phillips screwdriver to loosen the two lamp unit screws until the screws turn3 )freely. Pull up the handle, and pull out the lamp unit gently.Insert the new lamp unit in correct direction. Tighten the two lamp unit screws4 )securely with a Phillips screwdriver.Close the lamp cover, and tighten the Lamp cover screw securely with a Phillips5 )screwdriver.J Reset the Lamp Hours UsedAfter replacing the lamp unit, make sure to reset the usage time in the [Clear Lamp Hours] menu. (Æpage 44)