*2 The indicator will light as the following order:2.0 seconds (light) → 2.0 seconds (off)*3 The indicator will light as the following order:0.5 seconds (light) → 0.5 seconds (off)Notef If the power indicator is blinking in red in a cycle of 2.75 seconds (light) → 0.25 seconds (off) →0.75 seconds (light) → 0.25 seconds (off) → 0.75 seconds (light) → 0.25 seconds (off), please consult your dealer.Powering On the ProjectorBefore switching on the projector, make sure all the other devices are correctly connected (x page 31) and remove the lenscap.3) 3)2) 1)1) Connect the power cord to the projector body.2) Connect the power plug to an outlet.f The power indicator lights or blinks, and the projector will enter the standby mode.3) Press the power button <v/b> on the control panel or on the remote control.f The power indicator lights in green and the image is soon projected on the screen.Attentionf Be sure to remove the lens cap before starting projection.Notef If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO] (x page 73), it maytake approx. 10 seconds longer before the projector starts projecting after the power is turned on, compared with when[NORMAL] is set.f If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [NORMAL], it may takeapprox. 1 minute to enable the network function after connecting the power cord.When the initial setting screen is displayedWhen the projector is switched on for the first time after purchase as well as when [INITIALIZE ALL] in the [PROJECTORSETUP] menu is executed, the focus adjustment screen is displayed after projection starts, then the initial setting screen isdisplayed. Set them in accordance with circumstances.In other occasions, you can change the settings by menu operations.Initial setting (display language)Select the language to show on the screen.After completed the initial setting, you can change the display language from the [LANGUAGE] menu.1) Press asqw to select the display language.2) Press the button to proceed to the initial setting.Chapter 3 Basic Operations - Powering on/off the projector36 - ENGLISH
