Panasonic PV-GS80 Operating Instructions Manual

Also see for Palmcorder PV-GS85: Instrucciones de funcionamiento Operating instructions

Contents

Before usingQuick Start®iiiii IIII_IIIIIIIIIIIIIIIII_IIIIIIIIIIIIIIIII_IIII_IIII_I_I_IIIII_IIIIIIIIIIIII_IIIIIIII_IIII_IIIIIIIIIIIIIIIIIII_IIIIIIIIiii_w_;When Quick Start is ON the battery power is stillbeing consumed, even when the LCD Monitorand the Viewfinder are closed.The Camcorder will resume recording/pausemode about 1.7 seconds after the LCD Monitorand the Viewfinder are reopened.• Please note in Quick Start Mode approximatelyhalf the pause recording power is beingconsumed.Using Quick Start Mode will reduce the batteryrecording/playback time.• This is only activated in the following cases.• While using the batteryA tape or a card is inserted while TapeRecording Mode is set.A card is inserted while Card RecordingMode is set.• While using the AC adaptorQuick Start can be used even if a tape/cardis not inserted.• Set to Tape/Card Recording Mode.1 Set [SETUP] >> [QUICK START] >> [ON].(-2:r-)2 While the [OFF/ON] switch is still set to[ON], close the LCD monitor and retract theViewfinder.OFF ON ®• The Status indicator lights green and the unitgoes into quick start standby mode.• The Camcorder will not go into quick startstandby mode unless the LCD monitor isclosed and the viewfinder is retracted.3 Open the LCD monitor or extend theViewfinder.OFF ON• The Status indicator lights red and theCamcorder is put into recording pauseapprox. 1.7 seconds after it is turned on.• To cancel Quick Start1 Set [SETUP] >> [QUICK START] >> [OFF].(-23-)• If the [OFF/ON] switch is set to [OFF] while theunit is in quick start standby mode, the powerturns off.• If the standby continues for approx. 30 minutes,then the Status indicator will go off and theCamcorder will be completely turned off.• In the following cases, quick start is canceledand the power turns off.• When the Mode dial is moved.• When the battery or AC adaptor is removed.• When both the tape and card are removedwhile using the battery in Tape RecordingMode.• When the card is removed while using thebattery in Card Recording Mode.• When the Camcorder is quick-started with thewhite balance on automatic, it may take sometime until the white balance is adjusted if thescene being recorded has a light sourcedifferent from the scene last recorded. (Whenthe MagicPix function is used, however, thewhite balance of the scene last recorded isretained.)• If the power is turned on in quick start standbymode, the zoom magnification becomes 1X andthe picture size may differ from what it wasbefore quick start standby.• if [POWER SAVE] (-28-) is set to [5 MINUTES]and the unit automatically goes into quick startstandby mode, set the [OFF/ON] switch to[OFF], then to [ON] again. Also, close the LCDmonitor and retract the viewfinder and thenopen the LCD monitor or extend the viewfinderagain.18LSQT1121