5Getting StartedImportant Safeguards15. Power Lines – An outside antenna systemshould not be located in the vicinity of overheadpower lines or other electric light or powercircuits, or where it can fall into such powerlines or circuits. When installing an outsideantenna system, extreme care should be takento keep from touching such power lines orcircuits as contact with them might be fatal.16. Overloading – Do not overload wall outletsand extension cords as this can result in arisk of fire or electric shock.17. Objects and Liquids – Never push objectsof any kind into this video unit throughopenings as they may touch dangerousvoltage points or short out parts that couldresult in a fire or electric shock. Never spillliquid of any kind onto the video unit.18. Servicing – Do not attempt to service thisvideo unit yourself as opening or removingcovers may expose you to dangerous voltageor other hazards. Refer all servicing toqualified service personnel.19. Damage Requiring Service – Unplug thisvideo unit from the wall outlet and referservicing to qualified service personnel underthe following conditions:a. When the power-supply cord or plug isdamaged.b. If any liquid has been spilled into, orobjects have fallen onto, the video unit.c. If the video unit has been exposed to rainor water.d. If the video unit does not operate normallyby following the operating instructions.Adjust only those controls that are coveredby the operating instructions, as an improperadjustment of other controls may result indamage and will often require extensivework by a qualified technician to restore thevideo unit to its normal operation.e. If the video unit has been dropped or thecabinet has been damaged.f. When the video unit exhibits a distinctchange in performance – this indicates aneed for service.20. Replacement Parts – When replacementparts are required, be sure the servicetechnician has used replacement partsspecified by the manufacturer or have thesame characteristics as the original part.Unauthorized substitutions may result in fire,electric shock or other hazards.21. Safety Check – Upon completion of anyservice or repairs to this video unit, ask theservice technician to perform safety checksto determine that the video unit is in safeoperating order.PrecautionsUSE & LOCATION• TO AVOID SHOCK HAZARD ... Your Camcorder and power supply should not be exposed to rain or moisture.Do not connect the power supply or operate your Camcorder if it gets wet. Your Camcorder has been designed foroutdoor use, in all kinds of weather, however it will probably not survive any type of direct exposure to water, rain,sleet, snow, sand, dust, or a direct splashing from a pool or even a cup of coffee. This action could permanentlydamage the internal parts of your Camcorder. Do not attempt to disassemble this unit. There are no userserviceable parts inside. Unplug your Camcorder from the power supply before cleaning.• DO NOT AIM YOUR CAMCORDER AT THE SUN OR OTHER BRIGHT OBJECTS.• DO NOT LEAVE THE CAMCORDER WITH THE EVF AIMED DIRECTLY AT THE SUN AS THIS MAY CAUSEDAMAGE TO THE INTERNAL PARTS OF THE EVF.• DO NOT EXPOSE YOUR CAMCORDER TO EXTENDED HIGH TEMPERATURE ... Such as, in direct sunlight,inside a closed car, next to a heater, etc... This action could permanently damage the internal parts of yourCamcorder.• AVOID SUDDEN CHANGES IN TEMPERATURE ... If the unit is suddenly moved from a cold place to a warmplace, moisture may form on the tape and inside the unit.• DO NOT LEAVE YOUR CAMCORDER OR THE POWER SUPPLY TURNED ON WHEN NOT IN USE.• STORAGE OF YOUR CAMCORDER ... Store and handle your Camcorder in a manner that will not subject it tounnecessary movement (avoid shaking and striking). Your Camcorder contains a sensitive pick-up device whichcould be damaged by improper handling or storage.CARE• TO CLEAN YOUR CAMCORDER ... Do not use strong or abrasive detergents when cleaning your Camcorderbody.• TO PROTECT THE LENS ... Do not touch the surface of the lens with your hand. Use a commercial camcorderlens solution and lens paper when cleaning the lens. Improper cleaning can scratch the lens coating.• TO PROTECT THE FINISH OF YOUR CAMCORDER ... Before handling your Camcorder, make sure your handsand face are free from any chemical products, such as suntan lotion, as it may damage the finish.