8Optional Controller (Remote Controller)Wireless Remote Controller / CZ-RWSC2One remote control can control a group of up to eight indoor units.8-3. Names and FunctionsREMOTE CONTROLLER1. Operation Display Displays the operation status.(The figure shows all the statuses.)2. Start/StopbuttonPressing this button once starts andpressing again stops the operation.The auto-flap display may bedifferent, depending on the installedunit.3. Fan speedbutton4. Swing/WindDirection button5. Timer settingbuttonUse for operating with a timer.6. Reset button Use this button after changing thebatteries.7. Cover Press at the top center and then slidedown.8. Transmitter9. Remote controlsensorDetects the temperature at the remotecontroller when detection has beenswitched to the remote control by thesensor button.10. Temperaturesetting buttonsraises the temperature setting1 at a time.lowers the temperature setting1 at a time.11. Filter button Press to turn off the filter lamp on thereceiver.12. Mode SelectbuttonPress to switch the operation mode.13. VentilationbuttonUse this when connected to anaftermarket fan. Pressing this buttonstarts and stops the fan. When the airconditioner is started or stopped, thefan starts or stops at the same time.( appears on the display of theremote control when the fan isoperating.)14. Addressbutton15. Sensor button Use this when switching to detect thetemperature at the remote control. Atshipping the default setting is set todetect the temperature at the unit. Atthis time is shown on the display.16. Clock button Use this when setting the clock.From this page on the names of remote controlbuttons will be abbreviated as the illustration of the“button”.E.g.: Start/Stop button123456789101211131415168-3
