15711.13 WIRELESS REMOTE CONTROL CZ-RWS1 / CZ-RWC1CZ-RWS1 (Cooling/Heating)CZ-RWC1 (Cooling only)• Before installing the infrared remote control, be sure to thoroughly read the “Precautions in terms of safety”section of the installation instructions provided with the indoor unit.• After installing the infrared remote control, carry out a test operation to check that the remote control functionsproperly and also explain the operation and cleaning procedures to the customer in accordance with the details inthe instruction manual. Furthermore, ask the customer to keep this installation instructions and the operationinstruction in a safe place for later reference.11.13.1 ACCESSORIES SUPPLIED WTH THE INFRARED REMOTE CONTROLNo. Name Qty. No. Name Qty.○1 Infrared Remote Control 1 ○4 Holder fixing screw 2○2 R03 battery 2○3 Holder 1○5 Installation instructions (This manual) 111.13.2 INFRARED REMOTE CONTROL OPERATION• The infrared remote control can be used to operate indoor units at a maximum range of 8 meters from directly infront of the indoor unit.• If the remote control is at an angle to the receptor unit, the operating range may become shortened.• If using a single remote control to operate several air conditioners, address setting will be required.• (To be discussed later.)INFRARED REMOTE CONTROL INSTALLATION PROCEDURE(Use the holder to store the remote control.)The remote control can be installed to the wall.○1 Secure the holder with the screws provided. (2 screwlocations)○2 Insert and remove the remote control by sliding it in/outfrom the top of the holder.TransmitterON/OFF switchCoverLCDRemote controller holderSecure the remote controllerholder to the wall using the 4mm pan screws (accessory).4 mm pan screws (accessory)Be sure to only use the accessoryscrews, otherwise the remotecontroller may become damaged.Note• The holder should be in a place where it is not exposed to any type of heat (such as direct sunlight or near astove).• The remote control may not transmit to the receiver properly while it is in the holder. Be sure to remove theremote control unit from the holder and face the receiver when operating it.
