16111.14 WIRED REMOTE CONTROL CZ-RT1• Before installing the wired remote control, be sure to thoroughly read the “Precautions in terms of safety” in theinstallation instructions provided with the indoor unit.• After installing the wired remote control, carry out a test operation to check that the remote control functionsproperly, and also explain the operation and cleaning procedures to the customer in accordance with the detailsin the instruction manual.Furthermore, ask the customer to keep this installation instructions and the operation instruction in a safe placefor later reference.11.14.1 ACCESSORIES SUPPLIED WITH THE WIRED REMOTE CONTROLName Q’ty Diagram RemarkRemote control 1Remote control cable 1 Connecting between the air conditioner unit and theremote control (Length 10 m)4 mm wood screw 3 Installing the remote control to the wall (1 spare)M4 screw 3 Installing the remote control to an outlet boxRound terminal 2 Connecting to the indoor unit terminal block11.14.2 NOTES REGARDING WIRED REMOTE CONTROL SET-UP LOCATION• Select a place where the remote control can be operated easily (after obtaining approval from the customer).• Install in a place which is away from direct sunlight and as free from humidity as possible.• Install in a place which is as flat as possible to avoid the remote control from warping (If installed to a wall with anuneven surface, damage to the LCD case or operation problems may result.)• Install in a place where the LCD can be seen easily. If the remote control is installed somewhere which is toohigh or too low, it may be difficult to read the LCD. (Standard height from the floor is 1.2 to 1.5 meters)• Avoid installing the remote control cable near refrigerant pipes or drain pipes.• Install the remote control cable at least 5 cm away from other electric wires (including stereo and televisioncables, etc.) to avoid mis-operation (electromagnetic noise).• If passing the remote control cable through a wall, be sure to install a water trap above the cable.• Allow sufficient space around the remote control as shown in the illustration below. Secure the lower case of theremote control to the wall or to an outlet box.(Unit: mm)30 or more 30 or more120 or more30 or moreRemotecontroller
