Panasonic SC-CH11 Operating Instructions Manual

Also see for SC-CH11: Operating instructions

Tape-to-tape recording from deck 1 to deck 2The recording level and the noise reduction effect of the original(playback) tape will be recorded on the new tape just as they werein the original recording.^ *113 1< O1 Insert the playback cassette into deck 1 andthe cassette you are recording on (the editingtape) into deck 2.•Advance the leader tape three or four revolutions.•You can also use the different types of tapes for each deck 1and 2.2 Press the TAPE input select button.3 Select the desired reverse mode."Z Single-sided recording (forward side only)c^ : Two-sided recording (forward side/reverse side)4 Press one of the one-touch tape edit buttons(NORMAL or HIGH) to select editing speed.NORMAL: When you wish to monitor the sound while re-cordingHIGH: When you wish to record at a high speed (about1 .7 times normal speed)The synchro start function starts tape-to-tape recording.If you wish to monitor the sound of the tape with Dolby NR, set theDolby NR switch to the ON position (only for normal speed re-cording).Notes:•While tape-to-tape recording is in progress, you cannot changethe editing speed.•Some TV sets generate noise that could be recorded duringtape-to-tape recording. To prevent tbe possibility of this, do notuse this system close to a TV set.O O- pREC PAUSE( )To briefly interrupt tape-to-tape recording(Also available from the remote control.)Press REC PAUSE.REC PAUSEC J•The cassette deck will go into the pause mode.•To resume recording, press one of the one-touch tape edit but-tons.To stop the tape-to-tape-recording(Also available from the remote control.)Press the stop button in the deck section.Both decks will stop.To record another tape on the remaining blanktapeWhen the deck 1 completes playing back and stops, the deck 2enters the recording standby mode;At that time, replace the original (playback) tapewith a new tape. Then press one of the one-touchtape edit buttons.