Panasonic SC-CH11 Operating Instructions Manual

Also see for SC-CH11: Operating instructions

Connect the LW/MW loop antenna providedwith this system.You must connect this antenna to receive LW/MW broadcasts.Connect the LW/MW loop antenna to the AM antenna termi-nal. (The indication AM used here includes both MW and LW.)You may attach the LW/MW antenna holder to the rear panelof the system or to a rack or other structure.Clamp the antenna to the holder and position the loop for thebest reception. To minimize noise pickup, keep the loop an-tenna away from the speaker cable, power cord, and metalsurfaces.Rear panelof the unit\LW/MW antenna holder(included)Screws (included)LW/MW loop antenna(included)Connecting the LW/MW loop antenna:LW/MW loop antenna(included)Connecting the LW/MW outdoor antenna (not included)You may need an outdoor antenna if you use this system in amountainous region or inside a reinforced-concrete building,etc.5-12 mConnect the speaker cables [for right (R) andleft (L) channels].Match the two wires from the left and right speaker cables withthe same colored levers of the speaker terminals, then insertthe wires into the respective terminals.For areas except for United KingdomBe sure to connect the striped wire to the negativeStripe fterminals.'e ©.LOOPANTAM ANT -Run between 5 and 1 2 mof vinyl-covered wirehorizontally along awindow or otherconvenient location.Connect an external unit, such as audio tapedeck (for playback only) or output terminals ofa VCR or TV (not included).Connecting external units:-AUX-|L /AUDIO\1R VDUT )Stereo connection cable(not included)Video cassette recorder(not included)Notes:•Connect speaker cables before connecting the AC powersupply.•The load impedance of any speaker used with this unit mustbe 6 ohms.Connection of speaker cables1. Strip off the outer ccovering, and twist thecenter conductor.2. Tilt the lever back andinsert the wire.3. Close the lever and pullthe wire gently to be surethat it is secure.Notes:To prevent damage tocircuitry, never short-circuitpositive (+) terminals andnegative (-) speaker wires.Be sure to connect onlypositive (+) wires to positive(+) terminals and negative(-) wires to negative (-)terminals.15 mm TwistX5 Connect the AC power supply cord after youhave connected all other cables and cords.Note:Configuration of the AC outlet and AC power supply corddiffer according to area.For United Kingdom/" e HouseholdAC outletFit a suitable plug to the AC powersupply cord.