Panasonic SC-CH7 Operating Instructions Manual

Also see for SC-CH7: Operating instructions

Front Panel Controls and Functions(continued)0 Sound effect level control (SOUND JOG)This control is used for adjusting the level of the ambienceenhancement effect and the equalization level.0 Ambience enhancement button (SPACE)This button is used to activate ambience enhancement mode.0 Spectrum mode-eelect/demonetratlon button(-SPECTRUM MODE—DEMO)This button is used to select one of the six spectrum curves. Ifyou press and hold this button, six types of sound effects(spectrum curve in combination with ambience enhani^m^t)will be sequentially changed (Demonstration mode).0 Super base IndicatorIlluminates when the super bass mode is activated.0 Super bass button (SUPER BASS)Virtien this button is pressed, the dynamic tow frequencyranges are boosted.0 Volume preset button (VOL. PRESET)This button is used to make a volume presetting.0 Volume level control (VOLUME)This control is used to adjust the volume level (-82 d6~0 dB). Note that -82 dB is the lowest volume setting and 0 dBis the highest level setting.0 Equalization function button (ON/FLAT)This button is used to switch the equalization correctionfunction. If no equalization correction is desired, press thisbutton agctin to cancel the function.0 Headphones Jack (PHONES)0 Microphone Jack (MIC)0 Equalization mode-select/recall button(-MODE—RECALL)This button is used to retrieve a pre-programmed equalizationcurve from the memory. If you press and hold this button, acurve you programmed can be retrieved.® Input selectors and IndicatorsThese selectors are used to select the sound source to beheard. When the sound source is selected, the indicatorabove the selector will illumirtate.@ Standby Indicator (STANDBY)This indicator illuminates when tiie power “STANDBY c!)/ON''switch of the unit or that of the remote control is switched“OFF". Its purpose is to alert the user of the constant supplyvoltage to the internal circuitry even with the power switchOFF.For this unit, even if this switch is switched to the “STANDBY*position, there is still a slight power consumption of about17 watts: this is in order to retain of the “most recent” memoryand the preset-memory functions.-16-