Panasonic SC-CH7 Operating Instructions Manual

Also see for SC-CH7: Operating instructions

Edit-Recording Compact DiscsYou can not edit more than 21 tracks. During edit-recording, the Edit mode has priority hence operationsYou can make a record with your desired tone quality and that can be performed are power switch-on/switch-oH and ievelambience enhancement effect. control adjustments.Sequenciai editing (NORMAL)During recording, silent gaps of approximately 4 seconds areinserted between tracks automatically (auto space function).The unit makes a tape with no blank at the end of side A.A tape such as follows will be made:Faded out at the end of side A(side A) f 1 St track I I 2nd track | I 3rd track ir^(side B) [ Sthtrack | I Sthtrack | |I Sthtrack nrThe track that has been faded Faded out if the tape endsout at the end of side A in the middle of the track1 Carry out the steps 1 and 2 of “Recording” onpage 40.Recording will take place automatically from the forward sideto the reverse side of the tape, so insert the tape with the sidefrom which you intend to record first facing toward you, thenenter the reverse mode2 Press the Input selector button on the ampli¬fier marked “CD”.3 Load a disc.4 Press the edit mode button once to indicate“C-AUTO”.Cassette deck will take up the leader tape automatically andthe edit indicator will illuminate.Edit indicator5 Press the play button.The ATLS function (See page 45.) will operate to adjust therecording level, and then recording will start.When edIt-recording has finished, the cassette deck automati¬cally creates a non-recorded passage of about four secondsin length, and then enters the recording standby mode.■ When the edit indicator and CD indicator on thecassette deck does not illuminateThe cassette deck is not ready to record because the tape is notloaded or the safety tab is broken, for example. Press the stopbutton on the CD player and repeat the procedure from step 1.■ To stop edit recordingPress the stop button on the cassette deck.The CD player will automatically stop.■ To record another disc on the tape leftWhen recording of the first disc has finished, the link indicatorilluminates and the CD player's time display indicates the amountof blank tape left over on side “B”. The tracks from a second disccan be recorded as indicated on page 45.After finishing recording the first disc using the sequenciai editing,tracks to be recorded on the tape leftover will not be displayed, butit is possibie to record cmother disc.If another disc is not going to be recorded, press the stop button onthe CD player.-42-