Panasonic SC-MAX9000 Operating Instructions Manual

Also see for SC-MAX5000: Operating instructions User manual

10 RQT0A6610Preparing mediaDisc1 Press [CD x] (main unit: [x OPEN/CLOSE]) toopen the disc tray.Put in a disc with the label facing up.Press again to close the disc tray.2 Press [CD/RADIO/AUX] to select “CD”.USBPreparationBefore you connect a USB device to the system, makesure you do a backup of the data.1 Decrease the volume and connect the USB deviceto the USB port.Hold the main unit when connecting or disconnectingthe USB device.2 Press [USB] (main unit: [MEMORY/USB]) to select“USB A” or “USB B”.USB status indicator lights up in red when selected.Note:Do not use a USB extension cable. The system cannotrecognise USB device connected through a cable.Bluetooth®You can connect and play an audio device wirelesslythrough Bluetooth ® .Preparation• Switch on the Bluetooth ® feature of the device and putthe device near the system.• Read the operating instructions of the device fordetails.█ Pairing a devicePreparationIf this system is connected to a Bluetooth® device,disconnect it (Z“Disconnecting a device”).1 Press [ ].If “PAIRING” is shown, continue with step 3.2 Press [PLAY MENU] to select “PAIRING” and thenpress [OK].3 Select “SC-MAX9000”, “SC-MAX7000” or“SC-MAX5000” from the Bluetooth ® menu of thedevice.If prompted for a passkey, input “0000”.The device connects with this system automaticallyafter pairing is complete.The name of the connected device is shown for a fewseconds.Using the main unit1 Press and hold [ –PAIRING] until “PAIRING” isshown.2 Select “SC-MAX9000”, “SC-MAX7000” or“SC-MAX5000” from the Bluetooth® menu of thedevice.Note:You can pair up to 8 devices with this system. If a 9th deviceis paired, the device that has not been used for the longesttime will be replaced.█ Connecting a devicePreparationIf this system is connected to a Bluetooth ® device,disconnect it (Z“Disconnecting a device”).1 Press [ ].“BLUETOOTH READY” is shown.2 Select “SC-MAX9000”, “SC-MAX7000” or“SC-MAX5000” from the Bluetooth® menu of thedevice.The name of the connected device is shown for a fewseconds.3 Start playback on the device.Note:• A device must be paired to connect.• This system can only connect to one device at a time.• When “BLUETOOTH” is selected as the source, thissystem will automatically try to connect to the lastconnected device. (“LINKING” is shown during thisprocess.)█ Disconnecting a device1 Press [ ].2 Press [PLAY MENU] to select “DISCONNECT?”.3 Press [Y, U] to select “OK? YES” and then press[OK].“BLUETOOTH READY” is shown.To cancel, select “OK? NO”.Using the main unitPress and hold [ –PAIRING] until “PAIRING” isshown.Note:A device is disconnected when you:• Select a different source.• Move the device out of the maximum range.• Disable the Bluetooth® transmission of the device.• Switch off the system or the device.