Panasonic SC-MAX9000 Operating Instructions Manual

Also see for SC-MAX5000: Operating instructions User manual

20 RQT0A6620OthersAuto offThis system automatically switches off when you do notuse it for approximately 20 minutes.1 Press [SETUP] to select “AUTO OFF”.2 Press [Y, U] to select “ON” and then press [OK].To cancel, select “OFF”.Note:This function does not work when you are in radio source orwhen a Bluetooth® device is connected.Bluetooth® standbyThis function automatically switches on the system whenyou establish a Bluetooth® connection from a paireddevice.1 Press [SETUP] to select “BLUETOOTH STANDBY”.2 Press [Y, U] to select “ON” and then press [OK].To cancel, select “OFF”.Note:Some devices may take longer to respond. If you areconnected to a Bluetooth ® device before switching off thesystem, wait for a minimum of 5 seconds before connectingto this system from your Bluetooth ® device again.Software versionYou can check the software version of the system.1 Press [SETUP] to select “SW VER.” and then press[OK].The software version is shown.2 Press [OK] again to exit.MaintenanceTo clean this system, wipe with a soft, dry cloth.• Never use alcohol, paint thinner or benzine to clean thissystem.• Before using chemically treated cloth, read theinstructions that came with the cloth carefully.TroubleshootingBefore requesting service, make the following checks. Ifyou are in doubt about some of the check points, or if thesolutions indicated do not solve the problem, consultyour dealer for instructions.█ Common problemsThe unit does not work.• The safety device has been activated. Do the following:1. Press [1] on the main unit to switch the unit to standbymode. If the unit does not switch to standby mode,– Press and hold the button for a minimum of10 seconds. Or,– Disconnect the AC mains lead and then connect itagain.2. Press [1] again to switch on the unit. If the problempersists, consult your dealer.The display panel lights up and changes continuously instandby mode.• Press and hold [8] on the main unit to select “DEMO OFF”.No operations can be done with the remote control.• Examine that the battery is installed correctly.Sound is distorted or no sound.• Adjust the volume of the system.• Switch off the system, determine and correct the cause,and then switch on again. It can be caused by straining ofthe speakers through excessive volume or power, andwhen using the system in a hot environment.A humming sound can be heard during playback.• An AC mains lead or fluorescent light is near the cables.Keep other appliances and cords away from the cables ofthis system.The sound level reduces.• The protection circuit has been activated due to thecontinuous use at high volume output. This is to protect thesystem and maintain the sound quality.█ DiscDisplay not shown correctly.Playback does not start.• You have not put in the disc correctly. Put it in correctly.• Disc is dirty. Clean the disc.• Replace the disc if it is scratched, warped, ornon-standard.• There is condensation. Let the system dry for 1 to 2 hours.The total number of tracks displayed is incorrect.The disc cannot be read.Distorted sound is heard.• You put in a disc that the system cannot play. Change to aplayable disc.• You put in a disc that has not been finalised.█ USBThe USB device or the contents in it cannot be read.• The format of the USB device or the contents in it are notcompatible with the system.• USB devices with storage capacity of more than 32 GBcannot work in some conditions.Slow operation of the USB device.• Large content size or large memory USB device takeslonger time to read.