Quick Guide• Inserting the batteryInstall the battery by inserting it in thedirection shown in the figure.O Insert the battery until it clicks andlocks.• Charging the battery1) Open the LCD monitor.2) Open the SD card cover and insert(remove) the SD card into (from) thecard slot.• Face the label side Q in the directionshown in the illustration and press itstraight in as far as it will go.• Press the center of the SD card and thenpull it straight out.3) Securely close the SD card cover.• How to turn on the powerTurning the power on and off with thepower buttonPress the power button to turn on the power.O Connect the AC adaptor to this unit'sDC input terminal.Connect the AC cable to the ACadaptor, then the AC outlet.• For the AC cable, plug in _ and then _).• The status indicator O will flash red at aninterval of 2 seconds, indicating that charginghas begun.• Inserting/removing an SD cardThe status indicator lights.• To turn offthe power, hold down the powerbutton until the status indicator goes off.Turning the power on and off with theLCD monitorPower is turned on when the LCD monitor isopened, and power is turned off when it isclosed.• To turn on the powerO The status indicator lights.• To turn off the powerAccess lamp [ACCESS] O• When this unit is accessing the SD card or :built, in memory the access tamp lights up. O The status indicator goes off.13VQT3E42