7WARNING:TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR PROD-UCT DAMAGE, DO NOT EXPOSE THIS APPLIANCE TO RAIN,SPLASHING, DRIPPING OR MOISTURE.CAUTION!THIS PRODUCT UTILIZES A LASER.USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OFPROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAYRESULT IN HAZARDOUS RADIATION EXPOSURE.DO NOT OPEN COVERS AND DO NOT REPAIR YOURSELF.REFER SERVICING TO QUALIFIED PERSONNEL.The product you have purchased is powered by a nickel-cadmium bat-tery which is recyclable. Please call 1-800-8-BATTERY for informationon how to recycle this battery.CAUTION:This equipment has been tested and found to comply with the limits for a ClassB digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful inter-ference in a residential installation. This equipment generates, uses and can ra-diate radio frequency energy and, if not installed and used in accordance withthe instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio or televi-sion reception, which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of thefollowing measures:≥Reorient or relocate the receiving antenna.≥Increase the separation between the equipment and receiver.≥Connect the equipment into an outlet on a circuit different from that to whichthe receiver is connected.≥Consult the dealer or an experienced radio/TV technician for help.Any unauthorized changes or modifications to this equipment would void theuser’s authority to operate this device.This device complies with Part 15 of the FCC Rules. Operation is subject to thefollowing two conditions: (1) This device may not cause harmful interference,and (2) this device must accept any interference received, including interferencethat may cause undesired operation.Ni-CdRBRCRBRCAttaching the BeltclipAttach the included beltclip to make it easier to carry while jogging.1 Insert the flange on the belt-clip into the slot on the baseof the unit.2 Press the beltclip firmlyagainst the base.3 Fit the screw into the hole inthe unit.4 Screw in the direction indi-cated.5 Clip on to your belt.BeltclipMaintaining the LensOpen the lid and clean the lens asshown in the figure.Use a cotton swab to gently wipeoff any finger-prints.Recommended product:Lens cleaner kit (SZZP1038C)Air blower forcamera lensLensLensProduct ServiceDo not attempt to remove the cover(s) or repair the unit yourself. Refer servicing toqualified personnel only.Product informationFor product service, product information or assistance with product operation, refer tothe servicenter directory.