24QUALITY Select the recording quality for the specified channel. Options are:LEVEL 1 (Low), 2, 3, 4 and 5 (High)RECORDING Assign the recording mode for each channel. Options are: Continuous,By Motion, By Sensor, By Schedule or Disable.SENSORRECORDINGEnable setting up to 4 sensors for the specified channel using themouse or the control button ( ) of the remote control.PRE RECORD Enable/disable pre-event recording. Options are: OFF, 15 seconds, 30seconds, 1 minute, 3 minutes and 20 minutes.POST EVENTRECORDSet the post event recording time duration for the specified channel.(10~60 seconds)AUDIO Enable/disable audio recording for the specified channel.z Fixed-available on only from channel 1 to channel 4.SCHEDULE Set the recording schedule. Press SEL to go to schedule setup screen.3-3-1. Recording SchedulesTo setup a recording schedule, select SCHEDULE in the RECORD menu. Navigate through the menuitems using the mouse or the control button ( ) on the remote control.[Channel]: Select the specific channel.[Setup]: Set up using the left button of the mouse to section under the specific day and time. It can set theall section under the specific day or time at a time when pressing the specific day or time. It is alsopossible to set up recording modes of various type using a Continue(green color), Motion(yellowcolor) and Sensor button(red color). It can set easy using a drag-and-drop function of a mousecontrol.[COPY Schedule]: Set the channel 1 schedule and select the square button of CH2 in COPY SCHEDULEsection using the mouse. And, press the COPY button. Then the CH1 schedule is copied to CH2. Toremove the setting value, press the CLEAR button.Figure 3.3.2. Schedule recording setup screen