Panasonic TC-P54Z1 Operating Instructions Manual

Also see for Viera TC-P54Z1: Quick start guide Specifications Service manual Technical guide Quick start guide

Panasonic TC-P54Z1 Operating Instructions Manual Manual pdf 12 page image

22 23Quick StartGuide First Time SetupFirst Time Setup (Continued)“First time setup” is displayed only when the TV is turned on for the first time after the power cord isinserted into a wall outlet and when “Auto power on” (p. 42-43) is set to “No”.■Press to exit froma menu screen■ Press to returnto the previousscreenSelect your viewing environment* This setting will be skipped next time if you select “Home Use”.Select your languageLanguageEnglish FrançaisEspañol selectokBe sure to select “Home Use”Please select your viewing environmentSelect “Home Use” when using this TV in your home.Home Use Store Demonstration selectokPlease confirm your selection (Home Use) before pressing OK button.■ If you select “Store Demonstration” by mistake in ,confirmation screen will be displayed.You are selecting the mode for store demonstrationYes NoIf you select “Yes”, the picture mode will regularly resetto “Vivid” and a Picture Refresh message will bedisplayed on the screen.selectokSelect “No” and return to previous screen .If you select “Yes”, Screen enters store demonstration mode.To display the “Please select your viewing environment” screen again asshown above and select “Home Use”, do one of the following:• Press and hold down the front POWER button.• Unplug the TV and plug it again.Auto channel setupSelect “ANT/Cable setup”First time setupLanguageVIERA CAST settingNetwork settingClockANT/Cable setupInput labelsnextselectSelect “ANT in”CableANT/Cable setupANT inAuto programsetselectANT inCable: Cable TVAntenna : AntennaNot used : Skip TV tuninggo to 5Select “Not used” when no wire is connected to the “Antenna/Cable” terminal.Typical when Cable/Satellite box is connected to a TV input.Prevents accidental tuning to an unavailable signal.■ Press to exit froma menu screenNoteTo change setting(Language/ANT/Cable setup/Network setting/VIERA CAST setting/Clock/Input labels)later, go to Menuscreen(p. 42)Select “Auto program”CableANT/Cable setupANT inAuto programnextselectSelect scanning mode (ALL channels/Analog only/Digital only)S l OKAuto programAll channelsAnalog onlyDigital onlyokselectAuto programProgressNumber of analog channelsNumber of digital channels8%100Press RETURN to quit.RETURNStart scanning the channelsAvailable channels (analog/digital) are automatically set.All channels: Scans digital and analog channelsAnalog only: Scans Analog channels onlyDigital only: Scans Digital channels onlyConfirm registered channelsprogramCancelApplyCaption Favorite Add...... Yes...... Yes...... Yeslselect “Apply”okIf OK is not pressed after selecting “Apply”, the channels will not be saved.The channel will be saved when no operation is performed for 60 seconds andthe “Manual program” menu will also exit automatically.If you perform scanning more than twice, previously saved channels are erased.Network settingFirst time setupLanguageVIERA CAST settingNetwork settingClockANT/Cable setupInput labelsselectokNetwork setting (p. 50-51)VIERA CAST settingFirst time setupLanguageVIERA CAST settingNetwork settingClockANT/Cable setupInput labelsselectokVIERA CAST setting (p. 52-53)