54Operating peripheral equipment using the remote controlProgramming The Illuminated Remote Control Using Access CodesThe Universal Remote Control can be programmed to operate many manufacturers’ components, using the componentfunction buttons for VCR, DVD, AUX, RCVR, TV, DTV CABLE or DBS. Follow the procedures for programming yourRemote Control with or without a code for the component.Determine the manufacturer of the component and look in the table for the code.1 Confirm that the external component is plugged in and operating.2 Turn the component off.3TVDTVCBLAUXDVDVCRDBSRCVR4POWER +ACTIONCHCHVOL VOL1 2 34 5 67 8095Press POWER and ACTION together, for at least 5 seconds.After 5 seconds, all the illuminated mode keys will begin to flash.Release the POWER and ACTION keys.Press the mode key.The mode key will illuminate steadily, all others will go out.Enter the 3-digit component code using the Remote Control numeric keypad.6 POWER Press the Remote Control POWER to test the component. If the procedure is successful,the component will turn on.If the component does not operate with the Remote Control, repeat theprocedure using another code. (Some brands have multiple codes).If an incorrect code is entered, or if the procedure takes longer than 30seconds,the programming will fail.Helpful Hints: Unsuccessful CodeDeviceTVDTVCABLEDBSVCRDVD/CDAUXRCVROperatesTV (Panasonic Only)DTV (Panasonic Only)CABLE (Preset)DBS (Preset)VCR (Preset)DVD and CD (Preset)Personal Video Recorders,Tape and VCR2Audio Receiver (Preset)DefaultPanasonic TV CodesPanasonic DTV CodesPanasonic CABLE CodesPanasonic DBS CodesPanasonic VCR CodesPanasonic DVD CodesPanasonic Personal VideoRecorders CodePanasonic RCVR CodeDefault Modes For Remote Control