Panasonic TH-37PR10B Operating Instructions Manual

9Connections167839451015 14 13 12 112Notes:• Due to space limitations, occasionally you may have trouble connecting Mini D-sub 15P cable with ferrite core to PC inputTerminal.• Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanningfrequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)• The display resolution is a maximum of 768 × 720 dots (TH-37PR10B), 768 × 768 dots (TH-42PR10B) when theaspect mode is set to “4:3”, and 1,024 × 720 dots (TH-37PR10B), 1,024 × 768 dots (TH-42PR10B) when the aspectmode is set to “16:9”. If the display resolution exceeds these maximums, it may not be possible to show fine detailwith sufficient clarity.• The PC input terminals are DDC2B-compatible. If the computer being connected is not DDC2B-compatible, you willneed to make setting changes to the computer at the time of connection.• Some PC models cannot be connected to the set.• There is no need to use an adapter for computers with DOS/V compatible Mini D-sub 15P terminal.• The computer shown in the illustration is for example purposes only.• Additional equipment and cables shown are not supplied with this set.• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specifiedfrequency range.• Component Input is possible with the pin 1, 2, 3 of the Mini D-sub 15P Connector.• Change the “Component/RGB-in select” setting in the “Setup” menu to “Component”(when Component connection) or “RGB” (when RGB signal connection). (see page 31)• To use sync input VBS signals, use the connector which incorporates a 75-ohm termination resistance and which isavailable on the market, for the connection of the HD connector where the VBS signals are to be input.Signal Names for Mini D-sub 15P ConnectorPin Layout for PC InputTerminalPC Input Terminals connectionAUDIOPC INCOMPUTERConversion adapter(if necessary) Mini D-sub 15pRGBPC cableStereo plugAudioConnect a cable which matchesthe audio output terminal on the computer.Pin No. Signal Name Pin No. Signal Name Pin No. Signal Name1 R (PR /CR ) 6 GND (Ground) 11 NC (not connected)2 G (Y) 7 GND (Ground) 12 SDA3 B (PB/CB ) 8 GND (Ground) 13 HD/SYNC4 NC (not connected) 9 NC (not connected) 14 VD5 GND (Ground) 10 GND (Ground) 15 SCL