Panasonic TH-42PS10BK Operating Instructions Manual

Also see for TH-42PH10BK: Operating instructions Service manual

Panasonic TH-42PS10BK Operating Instructions Manual Manual pdf 39 page image

1/2PCOffStandby save OffPower management OffAuto power off OffOSD Language English (UK)Component/RGB-in selectRGBInput labelSignalPower saveSetup3D Y/C Filter (NTSC)Colour systemSignalOnAutoCinema realityPanasonic Auto (4 : 3)Off4 : 3[ AV ]P-NR Off1/2PCOffStandby save OffPower management OffAuto power off OffOSD Language English (UK)Component/RGB-in selectRGBInput labelSignalPower saveSetup3D Y/C Filter (NTSC)Colour systemSignalOnAutoCinema realityPanasonic Auto (4 : 3)Off4 : 3[ AV ]P-NR OffCinema realityP-NRSignalOffOff[ Component ]Cinema realityP-NRSignalOffOffH-Freq.V-Freq.kHzHz33.860.0[ Digital ]SyncP-NRSignalAutoH-Freq.V-Freq.kHzHz33.860.0[ RGB ]Cinema reality OffOff39Setup for Input SignalsColour system / Panasonic AutoSelect Signal from the “Setup” menu during AV(S Video) input signal. (“Signal[AV]” menu is displayed.)Press to select the “Colour system” or“Panasonic Auto”.Press to select each functions.If the picture image becomes unstable:With the system set on Auto, under conditions of low level or noisy inputsignals the image may in rare cases become unstable. Should this occur,set the system to match the format of the input signal.Cinema reality / P-NRPress to select Cinemareality or P-NR.Press to set On / Off.Press to exit from adjust mode.Cinema reality:When on, the display attempts to reproduce a more natural interpretation of sourcessuch as movie pictures, which are recorded at 24 frames per second.If the picture is not stable, turn the setting to off.Note:When On, this setting only affects the following signal input:• NTSC / PAL signal input during “AV(S Video)” input signal.• 525i(480i) 625i(575i), 1125(1080) / 60i signal input during “Component” inputsignal.P-NR:Automatically reduces unwanted picture noise.Note:P-NR cannot be adjusted while a PC signal is being applied.12Press ACTION ( ) buttonPress ACTION ( ) buttonMode FunctionColour system Set the colour system to match the input signal. When selecting “AUTO”, the colour system is automaticallyselected from NTSC/PAL/SECAM, however, M.NTSC signal is not displayed properly depending on theattached terminal board. To display M.NTSC signal, select “M.NTSC” in Colour system.Auto SECAM M.NTSC NTSCPALPanasonic Auto(4 : 3)Set to “4 : 3” to view 4:3 images in an unchanged format when Panasonic Auto is selected.If you would like to view 4:3 images in Just format, set to “Just”.Note:Panasonic Auto does not function when BNC Dual Video Terminal Board (TY-FB9BD) is used.