Panasonic TH-42PW4 Operating Instructions Manual

Also see for Viera TH-37PWD4: Service manual Operating instructions User guide Operating instructions Operating instructions

35Pull-in rangeSelect Signal from the “Setup” menu during RGB or PC input signal mode.Press to select each item.Press to adjust.The following operation methods are the same for both the Signal [RGB]and Signal [PC].SyncSync H & VSync on VIDEOSync on GSetting RGB sync signal:Confirm that the input is set to RGB INPUT (this setting is valid only for RGB INPUT).H&V: The H and V sync signals are input from the HD/VD connector.on G: Uses a synchronized signal on the Video G signal, which is inputfrom the G connector.on VIDEO: Compatible with the scart plug (Europe)The composite video signal input from the VIDEO input terminal isused by dividing the sync signals.Sets the width for different frequencies.(This setting is the same for both Signal [RGB] and Signal [PC].)Setting PC sync signal:Confirm that the input is set to PC INPUT (this setting is valid only for PC INPUT).H&V: The H and V sync signals are input from the HD/VD connector.on G: Uses a synchronized signal on the Video G signal, which is input from the G connector.Pull-in rangeWidePull-in rangeNarrowDisplays the H (Horizontal)/V (Vertical) frequencies.This display is valid only for RGB input and PC input.Display range:Horizontal 15.5 - 110 kHzVertical 48 - 120 HzH-Freq (kHz)/V-Freq (Hz)H - Freq. kHzV - Freq. Hz31.560.0Setup for Input SignalsClamp positionAdjusts the clamp position.The following operation methods are the same for “Signal” menu duringComponent, RGB and PC input signal mode.Normally, these adjustments are set to appropriate levels and therefore, do notneed to be altered.Clamp positionSignal [ RGB ]SyncPull-in rangeH -Freq. kHzV -Freq. HzH & VNarrow31.560.0Clamp positionSignal [ PC ]SyncPull-in rangeH - Freq. kHzV - Freq. HzH & VNarrow31.560.0Clamp positionSignal [ Component ]Clamp position