77InstallationThe Video/Audio connection between components can be made with shielded video and audio cables. For bestperformance, video cables should utilize 75 ohm coaxial shielded wire. Cables are available from your dealer or electronicsupply store.Before you purchase any cables, be sure you know what type of output and input connectors your various componentsrequire. Also determine the length of cable you will need.Receiver LocationThis unit is intended to be used with the stand or bracket. Consult your dealer for available options. Position forcomfortable viewing. Avoid placing where sunlight or other bright light (including reflections) will fall on the screen.Use of some types of fluorescent lighting can reduce remote control transmitter range.Adequate ventilation is essential to prevent internal component failure. Keep away from areas of excessive heat ormoisture.Optional External EquipmentRemote Control Battery InstallationFor frequent remote control users, replace oldbatteries with alkaline batteries for longer life.Helpful Hints:Whenever you remove the batteries, you mayneed to reset the remote control infraredcodes. We recommend that you record the codeon page 54, prior to setting up the remote control.Helpful Hints:1. Open the cover. 2. Install the batteries and replace the cover.Note the correct polarity (+ and - ).Precaution on battery useIncorrect installation can cause battery leakage and corrosion thatwill damage the remote control transmitter.Observe the following precautions:1. Batteries should always be replaced as a pair. Always use newbatteries when replacing the old set.2. Do not combine a used battery with a new one.3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).4. Do not attempt to charge, short-circuit, disassemble, heat or burnused batteries.5. Battery replacement is necessary when remote control actssporadically or stops operating the TV set.Two AA size