Panasonic TH-58PZ850U Quick Start Manual

Also see for TH-46PZ850U: Technical guide Troubleshooting guide Operating instructions Service manual Operating instructions

37AdvancedNetwork SettingThe network settings become effective when you close the menu and run “Connection test”.Check that the network settings are as shown below, and then start “Connection test”.Select “Connection test” and press OK.Succeeded : “Connection test” succeededFailed: Check the broadband environment connectionand settings and the network settings, and thenperform the test again.Test in progress---: Test not yet performed*Press OK again to cancel the test.(It takes a while to cancel the test.)Network setting 1/2Connection test SucceededIP setting mode ManualIP address 192.168.0.5Sub netmask 255.255.255.0Default gateway 192.168.0.254selectokSelect “IP setting mode” and set to “Automatic”. ■ Manual settingSelect “IP setting mode” and set to “Manual”Select the item and press OKCheck the specifications of the broadband router andenter each IP address.(When IP automatic acquisition in DHCP can be used)Network setting 1/2Connection test SucceededIP setting mode AutomaticIP address 192.168.0.5Sub netmask 255.255.255.0Default gateway 192.168.0.254The acquired address is displayed.selectok Sub netmask OK10 IchangechannelokorEach IP address is acquired automatically.Select “DNS setting mode” and set to “Automatic”.(When DNS automatic acquisition in DHCP can be used)Network setting 2/2DNS setting mode OKPrimary DNS 192.168.0.20AutomaticSecondary DNS 192.168.0.21LAN d tti M lThe acquired address is displayed.selectokEach IP address is acquired automatically.If you are using a broadband router, IP automaticacquisition in DHCP can be used under normalcircumstances. If you are not sure, check with theperson who installed the equipment, or check theinstructions for each device.■ Manual settingSelect “DNS setting mode” and set to “Manual”Select the item and press OKEnter each IP address as was specified by theprovider.Primary DNS 10 IselectokorSelect “LAN speed setting” (Default is “Automatic”) Normally, select “Automatic”.If “Connection test” failed, set the “LAN speed setting”to “manual” and then select “10BASE half duplex”,“10BASE duplex”, “100BASE half duplex” or “100 BASEduplex”.Cannot be selected when the “LAN speed setting” is“Automatic”.Changing the settings may make it impossible toconnect some types of equipment.Network setting 2/2DNS setting mode OKPrimary DNS 192.168.0.20AutomaticSecondary DNS 192.168.0.21LAN speed setting AutomaticLAN speed 10BASE half duplexselectadjustSelect “Software update” Press OK to start the software update screen.Follow directions of the screen.* Set “Clock” first. (p. 15)Network setting 2/2DNS setting mode OKPrimary DNS 192.168.0.20AutomaticSecondary DNS 192.168.0.21LAN speed setting AutomaticLAN speed 10BASE half duplexSoftware updateselectok