57FAQs, etc.Technical Information16 7 8394 51015141312112Pro settingNormal: Resets all Pro setting adjustments to factory default settings. (Set/No)Panel brightness: Selects the display panel brightness.(High: Vivid, Mid: Standard, Low: Studio ref)Contour emphasis: Adjusts the contour emphasis of the image. (On/Off)Gamma adjust: Gamma correction. Adjusts the intermediate brightness of the image. (Normal/Mid/Full 1/Full 2)Black extension: Adjusts the dark shades of the image in gradation.W/B high R: Adjusts the white balance for light red areas.W/B high B: Adjusts the white balance for light blue areas.W/B low R: Adjusts the white balance for dark red areas.W/B low B: Adjusts the white balance for dark blue areas.AGC: Increases the brightness of dark signal automatically. (On/Off)Input signal that can be displayed* Mark: Applicable input signal for Component (Y, P B, PR ), HDMI and PChorizontal frequency (kHz) vertical frequency (Hz) COMPONENT HDMI PC525 (480) / 60i 15.73 59.94 * *525 (480) /60p 31.47 59.94 * *750 (720) /60p 45.00 59.94 * *1,125 (1,080) /60i 33.75 59.94 * *1,125 (1,080) /60p 67.43 59.94 *1,125 (1,080) /60p 67.50 60.00 *1,125 (1,080) /24p 26.97 23.98 *1,125 (1,080) /24p 27.00 24.00 *640 × 400 @70 31.47 70.08 *640 × 480 @60 31.47 59.94 *Macintosh13” (640 × 480) 35.00 66.67 *640 × 480 @75 37.50 75.00 *852 × 480 @60 31.47 59.94 *800 × 600 @60 37.88 60.32 *800 × 600 @75 46.88 75.00 *800 × 600 @85 53.67 85.08 *Macintosh16” (832 × 624) 49.73 74.55 *1,024 × 768 @60 48.36 60.00 *1,024 × 768 @70 56.48 70.07 *1,024 × 768 @75 60.02 75.03 *1,024 × 768 @85 68.68 85.00 *Macintosh 21” (1,152 × 870) 68.68 75.06 *1,280 × 1,024 @60 63.98 60.02 *1,366 × 768 @60 48.36 60.00 *NoteSignals other than above may not be displayed properly.The above signals are reformatted for optimal viewing on your display.PC Input Terminals ConnectionComputer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning frequencyof 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)Some PC models cannot be connected to the set.There is no need to use an adapter for computers with IBM PC/AT compatible D-sub 15P terminal.The maximum resolution: 1,280 × 1,024If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity.Signal Names for D-sub 15P ConnectorPin No. Signal Name Pin No. Signal Name Pin No. Signal NameR GND (Ground) NC (not connected)G GND (Ground) NCB GND (Ground) HD/SYNCNC (not connected) NC (not connected) VDGND (Ground) GND (Ground) NCPin Layout for PC Input Terminal