- 143 -Power off LinkSet Power off Link to On in the Setup Menu to use this function.Settings Setup VIERA Link SettingsWhen the TV is set to Standby mode, the connected equipment is alsoautomatically set to Standby.● This function will work even if the TV enters Standby mode automaticallyby auto power standby function.Standby Power SaveSet Standby Power Save to On in the Setup Menu to use this function.Settings Setup VIERA Link SettingsThe power consumption of the connected equipment in Standby mode iscontrolled higher or lower in synchronisation with the TV on / off state toreduce the consumption.When the TV is set to Standby mode, the connected equipment isautomatically set to Standby and the power consumption of the connectedequipment is automatically minimised.When the TV is turned on, the connected equipment is still in Standby mode,but the power consumption is increased to start the connected equipmentfast.● This function is effective if the connected equipment can change the powerconsumption in Standby mode and is set to higher consumption.● This function works when Power off Link is set to On.Intelligent Auto StandbySet Intelligent Auto Standby to On in the Setup Menu to use this function.Settings Setup VIERA Link SettingsWhen the TV is on, non-used connected equipment goes into Standby modeautomatically to reduce the power consumption. For example, when the inputmode is switched from HDMI or when Speaker Selection is changed to TV(except for watching a disc).● This function may not work properly depending on the connectedequipment. In this case, set to Off.VIERA Link ControlYou can control some functions of the connected equipment with this TV’sremote control by pointing at the TV’s signal receiver.1. Display APPS List with APPS2. Select VIERA Link with / / / and press OK to access3. Select VIERA Link Control with / and press OK to access